Home › Engine / Hybrid System › 2NZ-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL
RM19S0E _51 Engine / Hybrid System _051451 2NZ-FE ENGINE MECHANICAL _0248089 REAR CRANKSHAFT OIL SEAL A

2NZ-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 1.REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)

Hide 30300 2.REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)

Hide 31210 3.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)

Hide 31250 4.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)

Hide 32101B 5.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)

A166739E01
2.63,1.619 2.935,1.773 0.304,0.155 10 SST 1.954,2.054 2.592,1.726 false

a.

Hold the crankshaft with SST.

SST
09960-10010  (09962-01000, 09963-01000)


b.
U158064

Remove the 6 bolts, rear drive plate spacer, drive plate and ring gear sub-assembly, and front drive plate spacer.


Hide 13405 6.REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)

A166739E01
2.63,1.619 2.935,1.773 0.304,0.155 10 SST 1.954,2.054 2.592,1.726 false

a.

Hold the crankshaft with SST.

SST
09960-10010  (09962-01000, 09963-01000)


b.
A166741

Remove the 6 bolts and flywheel.


Hide 11401L 7.REMOVE REAR ENGINE OIL SEAL

A166928E06
2.896,0.708 2.219,1.156 true 0.604,1.521 0.813,1.688 0.208,0.167 10 false *a 2.906,0.594 3.115,0.76 0.208,0.167 10 false *1

a.

Using a knife, cut off the lip of the oil seal.

Text in Illustration
*1 Protective Tape
*a Cut Position


b.

Using a screwdriver with its tip wrapped with tape, pry out the rear engine oil seal.

NOTICE:

After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.