Home › Engine / Hybrid System › CRUISE CONTROL › CLUTCH SWITCH
RM19S0E _51 Engine / Hybrid System _051464 CRUISE CONTROL _0248155 CLUTCH SWITCH A

CRUISE CONTROL  CLUTCH SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).


PROCEDURE

Hide 84520E 1.INSTALL NO. 2 CLUTCH START SWITCH ASSEMBLY

a.

Install the No. 2 clutch start switch assembly with the nut.

Torque:
16 N*m (160 kgf*cm, 12 ft.*lbf)


b.

Connect the connector.


Hide 73900 2.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

Hide 55432B 3.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)

a.

for LHD:

i.

Engage the 5 claws and 2 clips and install the instrument panel finish panel.



b.

for RHD:

i.

Engage the 6 claws and 2 clips and install the instrument panel finish panel.



Hide 55606 4.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)