Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB BOLT
RM19S0E _52 Drivetrain _051470 AXLE AND DIFFERENTIAL _0248208 FRONT AXLE HUB BOLT A

AXLE AND DIFFERENTIAL  FRONT AXLE HUB BOLT  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side as for the LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEELS

Hide 2.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 43512 3.REMOVE FRONT DISC

Hide 43502D 4.REMOVE FRONT AXLE HUB BOLT

a.
C235848E02
2.125,2.031 1.677,1.635 false 2.146,1.979 2.5,2.146 0.354,0.167 10 false SST 0.5,1.531 0.688,1.708 0.188,0.177 10 false *a 2.458,1.667 2.646,1.844 0.188,0.177 10 false *b

Using SST and a screwdriver or the equivalent to hold the axle hub, remove the hub bolt.

Text in Illustration
*a Hold
*b Turn

SST
09628-10011  


Hide 43502D 5.INSTALL FRONT AXLE HUB BOLT

a.
C235849E03
1.688,0.094 2.281,0.094 2.281,0.094 2.594,0.396 true 2.854,0.51 3.01,0.385 false 1.5,0.021 1.656,0.177 0.156,0.156 10 false *1 3,0.25 3.156,0.406 0.156,0.156 10 false *2 0.5,1.531 0.688,1.708 0.188,0.177 10 false *a 2.167,1.615 2.354,1.792 0.188,0.177 10 false *b

Install the washer and the nut onto a new axle hub bolt, as shown in the illustration.

Text in Illustration
*1 Washer
*2 Nut
*a Hold
*b Turn

Recommended Service Nut:
Thread Diameter Thread Pitch
12.0 mm (0.472 in.) 1.5 mm (0.0591 in.)


HINT:

Recommended thickness of the washer is 5 mm (0.197 in.) or more.



b.

Using a screwdriver or the equivalent to hold the axle hub, install the axle hub bolt by tightening the nut.


Hide 7.INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 8.INSTALL FRONT WHEELS

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)