Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB
RM19S0E _52 Drivetrain _051470 AXLE AND DIFFERENTIAL _0248209 FRONT AXLE HUB G

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side as for the LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 43512 3.REMOVE FRONT DISC

Hide 4.INSPECT FRONT AXLE HUB BEARING BACKLASH

a.
C130298

Using a dial indicator, check the backlash near the center of the axle hub.

Maximum:

0.05 mm (0.00197 in.)


If the backlash exceeds the maximum, replace the front axle hub bearing.


Hide 5.INSPECT FRONT AXLE HUB RUNOUT

a.
C130299

Using a dial indicator, check the runout of the surface of the axle hub.

Maximum:

0.05 mm (0.00197 in.)


If the runout exceeds the maximum, replace the front axle hub sub-assembly and front axle hub bearing.


Hide 7.INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 8.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)