Use the same procedure for the RH side as for the LH side.
The procedure listed below is for the LH side.
42450B
1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
Install the axle hub and bearing onto the axle beam with the 4 bolts.
2.INSPECT REAR AXLE HUB BEARING BACKLASH
3.INSPECT REAR AXLE HUB RUNOUT
89516D
4.CONNECT SKID CONTROL SENSOR WIRE (w/ ABS)
42403
5.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
6.INSTALL REAR WHEEL
7.INSPECT REAR WHEEL ALIGNMENT
8.CHECK SPEED SENSOR SIGNAL (w/ ABS)
9.CHECK SPEED SENSOR SIGNAL (w/ VSC)