Home › Suspension › REAR SUSPENSION › REAR COIL SPRING › 2011.08–2014.07
RM19S0E _53 Suspension _051473 REAR SUSPENSION _0248223 REAR COIL SPRING A

REAR SUSPENSION  REAR COIL SPRING  INSTALLATION  


PROCEDURE

Hide 48231B 1.INSTALL REAR COIL SPRING LH

a.

Install the rear coil spring lower insulator LH onto the rear axle beam assembly.


b.
C355415E01
2.406,0.594 2.719,0.792 0.313,0.198 10 false *a

Install the rear coil spring upper insulator LH so that its gap fits onto the end of rear coil spring LH.

Text in Illustration
*a Fit


c.
C233115

Install the rear coil spring LH onto the rear axle beam assembly.

Text in Illustration
V100144

Paint Mark

NOTICE:

The paint mark of the rear coil spring LH should be towards the underside and rear side of the vehicle.



Hide 48231A 2.INSTALL REAR COIL SPRING RH

HINT:

Use the same procedure for the RH side as for the LH side.


Hide 48540 3.TEMPORARILY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH

a.

Support the rear axle beam assembly with a jack. Insert a wooden block between the jack and the rear axle spring seat to prevent damage.


b.

Jack up the rear axle beam assembly slowly, and provisionally install the rear shock absorber assembly LH (lower side) with the bolt and nut onto the rear axle beam assembly.


Hide 48530 4.TEMPORARILY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY RH

HINT:

Use the same procedure for the RH side as for the LH side.


Hide 47319F 5.INSTALL REAR FLEXIBLE HOSE LH

a.

Connect the rear flexible hose LH onto the rear axle beam assembly with a new clip.


b.

Using a union nut wrench (10 mm), install the brake tube to the rear flexible hose LH while holding the rear flexible hose LH with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 47318F 6.INSTALL REAR FLEXIBLE HOSE RH

HINT:

Use the same procedure for the RH side as for the LH side.


Hide 89516D 7.INSTALL SKID CONTROL SENSOR WIRE LH (w/ ABS)

a.

Install the skid control sensor wire LH onto the rear axle beam assembly with the nut.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


b.

Connect the skid control sensor wire LH connector.


Hide 89516C 8.INSTALL SKID CONTROL SENSOR WIRE RH (w/ ABS)

HINT:

Use the same procedure for the RH side as for the LH side.


Hide 10.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 42110F 11.FULLY TIGHTEN REAR AXLE BEAM ASSEMBLY

Hide 48540 12.FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH

Hide 48530 13.FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY RH

HINT:

Use the same procedure for the RH side as for the LH side.


Hide 14.BLEED BRAKE LINE

Hide 15.BLEED CLUTCH LINE (for Manual Transaxle)