48231B
1.INSTALL REAR COIL SPRING LH
Install the rear coil spring lower insulator LH onto the rear axle beam assembly.
Install the rear coil spring upper insulator LH so that its gap fits onto the end of rear coil spring LH.
| *a | Fit |
Install the rear coil spring LH onto the rear axle beam assembly.
|
Paint Mark |
The paint mark of the rear coil spring LH should be towards the underside and rear side of the vehicle.
48231A
2.INSTALL REAR COIL SPRING RH
Use the same procedure for the RH side as for the LH side.
48540
3.TEMPORARILY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH
Support the rear axle beam assembly with a jack. Insert a wooden block between the jack and the rear axle spring seat to prevent damage.
Jack up the rear axle beam assembly slowly, and provisionally install the rear shock absorber assembly LH (lower side) with the bolt and nut onto the rear axle beam assembly.
48530
4.TEMPORARILY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY RH
Use the same procedure for the RH side as for the LH side.
47319F
5.INSTALL REAR FLEXIBLE HOSE LH
Connect the rear flexible hose LH onto the rear axle beam assembly with a new clip.
Using a union nut wrench (10 mm), install the brake tube to the rear flexible hose LH while holding the rear flexible hose LH with a wrench.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
47318F
6.INSTALL REAR FLEXIBLE HOSE RH
Use the same procedure for the RH side as for the LH side.
89516D
7.INSTALL SKID CONTROL SENSOR WIRE LH (w/ ABS)
Install the skid control sensor wire LH onto the rear axle beam assembly with the nut.
Connect the skid control sensor wire LH connector.
89516C
8.INSTALL SKID CONTROL SENSOR WIRE RH (w/ ABS)
Use the same procedure for the RH side as for the LH side.
9. STABILIZE SUSPENSION
10.INSTALL REAR WHEEL
42110F
11.FULLY TIGHTEN REAR AXLE BEAM ASSEMBLY
48540
12.FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH
48530
13.FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY RH
Use the same procedure for the RH side as for the LH side.
14.BLEED BRAKE LINE
15.BLEED CLUTCH LINE (for Manual Transaxle)
(See page Drivetrain>CLUTCH>CLUTCH SYSTEM>BLEEDING)
16.INSPECT REAR WHEEL ALIGNMENT
17. CHECK SPEED SENSOR SIGNAL (w/ ABS)
18. CHECK SPEED SENSOR SIGNAL (w/ VSC)