The skid control ECU (brake actuator assembly) is connected to the combination meter via CAN communication.
Refer to Brake Warning Light Remains ON (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>Brake Warning Light Remains ON).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
A
B
Disconnect the skid control ECU connector.
Turn the ignition switch to ON.
Check that the brake warning light comes on.
| Result | Proceed to |
|---|---|
| NG | A |
| OK (for LHD) | B |
| OK (for RHD) | C |
Reconnect the skid control ECU connector.
A
B
C
A
B
C