| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1428 | With the ABS motor relay OFF and the ABS motor fail safe relay ON, an open in the motor circuit continues for 2 seconds or more. | Brake actuator assembly (Motor circuit) |
Refer to DTCs C146C and C146D (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>C146C).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A55-13 (GND2) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Skid control ECU) |
| Result | Proceed to |
|---|---|
| NG | A |
| OK (for LHD) | B |
| OK (for RHD) | C |
A
B
C