Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR › from 2014.07
RM19S0E _54 Brake _051475 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0248231 REAR SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR  INSTALLATION  


PROCEDURE

Hide 42450B 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

a.

Install the axle hub and bearing onto the axle beam with the 4 bolts.

Torque:
90 N*m (918 kgf*cm, 66 ft.*lbf)

HINT:

The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.



Hide 42450B 2.INSPECT REAR AXLE HUB BEARING BACKLASH

Hide 89516D 4.CONNECT SKID CONTROL SENSOR WIRE

a.

Connect the skid control sensor wire connector.


Hide 42403 5.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY

Hide 6.ADJUST REAR DRUM BRAKE SHOE CLEARANCE

Hide 7.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)