The skid control ECU (brake actuator assembly) is connected to the combination meter via CAN communication.
Refer to ABS Warning Light Remains ON (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor)>ABS Warning Light Remains ON).
When replacing the skid control ECU, perform zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor)>CALIBRATION).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
A
B
Disconnect the skid control ECU connector.
Turn the ignition switch to ON.
Check that the ABS warning light comes on.
| Result | Proceed to |
|---|---|
| NG | A |
| OK | B |
Reconnect the skid control ECU connector.
A
B
A
B