Home › Audio / Visual / Telematics › AUDIO / VIDEO › QUARTER TRIM SPEAKER
RM19S0E _56 Audio / Visual / Telematics _051483 AUDIO / VIDEO _0248267 QUARTER TRIM SPEAKER A

AUDIO / VIDEO  QUARTER TRIM SPEAKER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the RH side.



PROCEDURE

Hide 1.REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side)

Hide 2.REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side)

Hide 3.REMOVE REAR SEAT ASSEMBLY (for Fold Down Seat Type)

Hide 62311B 5.SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP

Hide 73201C 6.REMOVE FRONT SEAT OUTER BELT BAR SUB-ASSEMBLY

Hide 62510P 7.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY

Hide 86160B 8.REMOVE REAR SPEAKER ASSEMBLY

a.
E229053

Disconnect the connector.


b.
E229054

Drill out the 3 rivet heads using a drill with a bit diameter of less than 4 mm (0.16 in.), and remove the rear speaker assembly from the quarter panel.


c.

Operate the drill around the rivet head circumference and cut out the flange.

CAUTION:

Be careful. The cut rivet is very hot.


NOTICE:

Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill the rivet head straight out.



d.

After drilling out the flange, continue drilling to push out the shards on the drill.


e.

Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the quarter panel.