Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM › 2011.08–2014.07
RM19S0E _58 Vehicle Interior _051491 THEFT DETERRENT / KEYLESS ENTRY _0248300 ENGINE IMMOBILISER SYSTEM S

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM  DIAGNOSTIC TROUBLE CODE CHART  


HINT:

If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.


Transponder Key ECU Assembly
DTC Code Detection Item Detection Enabling Condition (DTC Output Confirmation Operation) See page
B2780 Push Switch / Key Unlock Warning Switch Malfunction Insert the key into the ignition key cylinder (Click here)
B2784 Antenna Coil Open / Short Insert the key into the ignition key cylinder (Click here)
B2793 Transponder Chip Malfunction Insert the key into the ignition key cylinder (Click here)
B2794 Unmatched Encryption Code Insert the key into the ignition key cylinder (Click here)
B2795 Unmatched Key Code Insert the key into the ignition key cylinder (Click here)
B2796 No Communication in Immobiliser System Insert the key into the ignition key cylinder (Click here)
B2797 Communication Malfunction No. 1 Insert the key into the ignition key cylinder (Click here)
B2798 Communication Malfunction No. 2 Insert the key into the ignition key cylinder (Click here)

ECM
DTC Code Detection Item Detection Enabling Condition (DTC Output Confirmation Operation) See page
B2799 Engine Immobiliser System Malfunction Either condition is met:
- Within 10 seconds of an engine start operation being performed (with the shift lever in P and the brake pedal*1 or clutch pedal*2 depressed, turn the ignition switch to ON). If there is a malfunction, the engine stops (communication begins within 3 seconds of the engine start operation being performed, and DTCs are stored after 6 seconds).
- 10 seconds after the ignition switch is turned to ON after reconnecting the cable to the negative (-) battery terminal (communication begins within 3 seconds of the ignition switch being turned to ON, and DTCs are stored after 6 seconds).
(Click here)
B279A Theft Deterrent System Communication Line High Fixation Turn the ignition switch to ON and wait 6 seconds. (Click here)
B279C Theft Deterrent System Presence Detection Check for DTCs. (Click here)

*1: for Automatic Transaxle

*2: for Manual Transaxle