Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM › 2011.08–2014.07
RM19S0E _58 Vehicle Interior _051492 LIGHTING (INT) _0248303 LIGHTING SYSTEM J

LIGHTING (INT)  LIGHTING SYSTEM  Door Unlock Detection Switch Circuit  


DESCRIPTION

The main body ECU detects the condition of each door unlock detection switch.

WIRING DIAGRAM

E231472E01
1.876,1.337 2.087,1.489 0.210,0.152 10 H5 1.876,1.509 3.878,1.671 2.002,0.163 10 Front Door Lock Assembly LH*1 1.855,2.788 3.899,2.951 2.044,0.163 10 Front Door Lock Assembly RH*2 1.855,2.612 2.070,2.764 0.215,0.152 10 G5 2.142,2.237 3.668,2.400 1.525,0.163 10 Unlock Detection Switch 2.142,0.962 3.668,1.125 1.525,0.163 10 Unlock Detection Switch 5.769,3.146 6.786,3.297 1.017,0.151 10 Main Body ECU 5.601,1.915 5.780,2.062 0.178,0.147 10 18 5.884,2.078 6.269,2.220 0.385,0.142 10 LSFR 5.557,2.074 5.823,2.223 0.266,0.149 10 F76 5.557,0.808 5.823,0.957 0.266,0.149 10 F76 5.641,0.619 5.741,0.789 0.101,0.170 10 7 5.884,0.811 6.251,0.953 0.367,0.142 10 LSFL 3.782,1.997 3.882,2.167 0.101,0.170 10 7 1.921,0.722 2.022,0.892 0.101,0.170 10 7 1.921,1.997 2.022,2.167 0.101,0.170 10 8 3.782,0.722 3.882,0.892 0.101,0.170 10 8 3.351,0.72 3.738,0.894 0.387,0.174 10 LSSR 3.351,1.995 3.738,2.169 0.387,0.174 10 LSSR 2.062,1.995 2.171,2.169 0.110,0.174 10 E 2.062,0.72 2.171,0.894 0.110,0.174 10 E 4.521,2.708 5.225,2.868 0.705,0.161 10 *1: for LHD 4.521,3.009 5.262,3.169 0.742,0.161 10 *2: for RHD

PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Main Body / Data List.


e.

According to the display on the intelligent tester, read the Data List.

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
FR Door Lock Pos Front door unlock detection switch RH signal /
LOCK or UNLOCK
LOCK: Front door RH locked
UNLOCK: Front door RH unlocked
-
FL Door Lock Pos Front door unlock detection switch LH signal /
LOCK or UNLOCK
LOCK: Front door LH locked
UNLOCK: Front door LH unlocked
-

OK:

Normal conditions listed above are displayed.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.INSPECT FRONT DOOR LOCK ASSEMBLY
2.INSPECT FRONT DOOR LOCK ASSEMBLY
a.

Inspect the front door lock assembly (See page Vehicle Interior>DOOR LOCK>FRONT DOOR LOCK>INSPECTION).



OK

3.CHECK HARNESS AND CONNECTOR (FRONT DOOR LOCK ASSEMBLY - MAIN BODY ECU AND BODY GROUND)

NG

REPLACE FRONT DOOR LOCK ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (FRONT DOOR LOCK ASSEMBLY - MAIN BODY ECU AND BODY GROUND)
a.

for LHD

i.

Disconnect the H5 front door lock assembly LH connector.



b.

for RHD

i.

Disconnect the G5 front door lock assembly RH connector.



c.

Disconnect the F76 main body ECU connector.


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
for LHD
Tester Connection Condition Specified Condition
H5-8 (LSSR) - F76-7 (LSFL) Always Below 1 Ω
H5-8 (LSSR) - Body ground Always 10 kΩ or higher
H5-7 (E) - Body ground Always Below 1 Ω

for RHD
Tester Connection Condition Specified Condition
G5-7 (LSSR) - F76-18 (LSFR) Always Below 1 Ω
G5-7 (LSSR) - Body ground Always 10 kΩ or higher
G5-8 (E) - Body ground Always Below 1 Ω




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR