55303B
1.INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Using a nipper, cut off both ends of the runner portion shown in the illustration (When installing a new one).
| *a | Runner Portion |
| *b | Cut Off |
Engage the 9 guides to install the lower instrument panel sub-assembly.
Install the lower instrument panel sub-assembly with the 6 <B> or <C> bolts, <D> or <E> screw, 2 <F> or <H> or <H> or <I> bolts and bolt.
Engage the 2 claws to install the DLC3 connector.
Engage the clamps.
Connect the connectors.
53601
2.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Engage the 2 guides and claw to install the hood lock control lever sub-assembly.
58910C
3.INSTALL REAR CONSOLE BOX ASSEMBLY
55550
4.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
Engage the 3 guides and 2 hinges in the horizontal direction to install the glove compartment door assembly.
| *1 | Hinge |
| *2 | Guide |
Engage the 2 hinges in the horizontal direction, otherwise, installation failure caused by excessive play around the hinges will result.
While pushing in the sides of the glove compartment door assembly as indicated by the arrows in the illustration, close the door to engage it to the 2 stoppers.
55607
5.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Engage the guide and the 3 claws and install the instrument panel under cover.
55449D
6.INSTALL SWITCH BASE
Connect the connectors.
Engage the 2 guides and 3 clips to install the switch base.
55900
7.INSTALL AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)
8.INSTALL AIR CONDITIONING PANEL ASSEMBLY (for Manual Air Conditioning System)
73900
9.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
55606
10.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Engage the guide and the claw.
Install the No. 1 instrument panel under cover with the 2 <A> screws.
55539
11.INSTALL SPARE SWITCH HOLE COVER
Engage the 2 claws to install the spare switch hole cover.
84870A
12.INSTALL OUTER MIRROR SWITCH ASSEMBLY
55539
13.INSTALL SPARE SWITCH HOLE COVER
Engage the 2 claws to install the spare switch hole.
14.INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (w/ Radio Receiver)
15.INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)
55405B
16.INSTALL INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY (w/ Audio)
55521C
17.INSTALL STEREO OPENING COVER WITH BRACKET
Align the 2 holes in the radio bracket with the 2 bosses of the instrument panel.
Install the radio stereo opening cover with bracket with the 4 screws.
62111C
18.INSTALL COWL SIDE TRIM BOARD RH
62112
19.INSTALL COWL SIDE TRIM BOARD LH
Use the same procedure as for the RH side.
67913
20.INSTALL FRONT DOOR SCUFF PLATE RH
67914
21.INSTALL FRONT DOOR SCUFF PLATE LH
Use the same procedure as for the RH side.
55302A
22.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY