Home › Vehicle Interior › DOOR LOCK › KEY REMINDER WARNING SYSTEM › 2014.07–2017.01
RM19S0E _58 Vehicle Interior _051490 DOOR LOCK _0248290 KEY REMINDER WARNING SYSTEM Y

DOOR LOCK  KEY REMINDER WARNING SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use these procedures to troubleshoot the key reminder warning system.

·

*: Use the intelligent tester.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
a.

Check the battery voltage.

Standard voltage:

11 to 14 V


HINT:

If the voltage is below 11 V, recharge or replace the battery before proceeding.



Result:
Proceed to
NEXT



NEXT

3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
a.

Use an intelligent tester to check if the CAN communication system is functioning normally.

HINT:



Result:
Result Proceed to
DTC is not output A
DTC is output (for Separate Type Yaw Rate Sensor) B
DTC is output (except Separate Type Yaw Rate Sensor) C



A

4.PROBLEM SYMPTOMS TABLE

B

C

4.PROBLEM SYMPTOMS TABLE
Result:
Result Proceed to
Fault is not listed on Problem Symptoms Table A
Fault is listed on Problem Symptoms Table B



A

5.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

6.REPAIR OR REPLACE
5.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

6.REPAIR OR REPLACE
6.REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

7.CONFIRMATION TEST
7.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END