Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › from 2016.09
RM19S0E _51 Engine / Hybrid System _051464 CRUISE CONTROL _0248153 CRUISE CONTROL SYSTEM J

CRUISE CONTROL  CRUISE CONTROL SYSTEM  Clutch Switch Circuit  


DESCRIPTION

While depressing the clutch pedal, the clutch switch sends a signal to terminal 81 (D) of the ECM. The ECM cancels cruise control when terminal 81 (D) receives the signal.

WIRING DIAGRAM

B283123E37
0.208,0.906 1.167,1.25 0.958,0.344 10 false from EFI MAIN Relay 3.177,1.5 4.344,1.854 1.167,0.354 10 false No. 2 Clutch Start Switch Assembly 6.063,2.344 6.406,2.5 0.344,0.156 10 false ECM 1.979,1.125 2.625,1.302 0.646,0.177 10 false EFI NO. 2 3.177,1.344 4,1.521 0.823,0.177 10 false A41 6.063,2.188 6.385,2.365 0.323,0.177 10 false B89 5.833,0.979 6.01,1.156 0.177,0.177 10 false D 5.552,0.875 5.844,1.115 0.292,0.24 10 false 81 4.26,0.896 4.385,1.073 0.125,0.177 10 false 2 3.156,0.896 3.281,1.073 0.125,0.177 10 false 1

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.INSPECT NO.2 CLUTCH START SWITCH ASSEMBLY
a.

Inspect the no. 2 clutch start switch assembly (See page Engine / Hybrid System>CRUISE CONTROL>CLUTCH SWITCH>INSPECTION).



OK

2.CHECK HARNESS AND CONNECTOR (NO. 2 CLUTCH START SWITCH ASSEMBLY - ECM AND BATTERY)

NG

REPLACE CLUTCH START SWITCH ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (NO. 2 CLUTCH START SWITCH ASSEMBLY - ECM AND BATTERY)
a.

Disconnect the A41 no. 2 clutch start switch assembly connector.


b.

Disconnect the B89 ECM connector.


c.
U158209E03
1.625,0.396 2.146,0.677 0.521,0.281 10 false A41 0.177,0.094 0.344,0.25 0.167,0.156 10 false *a

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
A41-1 - Body ground Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V


Text in Illustration
*a Front view of wire harness connector
(to No.2 Clutch Start Switch Assembly)


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A41-2 - B89-81 (D) Always Below 1 Ω
A41-2 - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR