Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › from 2017.01
RM19S0E _58 Vehicle Interior _063185 PRE-CRASH SAFETY _0307822 PRE-CRASH SAFETY SYSTEM J

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  Laser Sensor Inspection  


DESCRIPTION

The pre-crash safety city sensor determines the distance between this vehicle and a preceding vehicle using the laser sensor.

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the pre-crash safety city sensor, replace it with a new one and be sure to initialize the settings. If a pre-crash safety city sensor which was installed to another vehicle is used, the information stored in the pre-crash safety city sensor will not match the information from the vehicle and, as a result, a DTC may be stored.

·

If the pre-crash safety city sensor has been replaced, or the windshield glass has been replaced or removed/installed, be sure to perform Recognition Camera/Target Position Memory and Recognition Camera Axis Adjust.

·

Perform adjustment using "ONE TIME RECOGNITION" or "SEQUENTIAL RECOGNITION".



PROCEDURE

1.READ VALUE USING GTS
a.

Position this vehicle and another vehicle as shown in the illustration, and then measure the distance between this vehicle and the preceding vehicle.


B415864E02
0.25,0.771 0.521,1 0.271,0.229 10 false *a 1.219,0.688 1.49,0.917 0.271,0.229 10 false *d 1.708,1.719 1.979,1.948 0.271,0.229 10 false *c 2.115,0.781 2.385,1.01 0.271,0.229 10 false *b

Text in Illustration
*a This Vehicle
*b Preceding Vehicle
*c 1.47 m (4.82 ft.)
*d 1.53 m (5.02 ft.)

NOTICE:

Perform the measurement indoors in an area where sunlight will not shine directly on the pre-crash safety city sensor.


HINT:
·

The distance between the pre-crash safety city sensor (laser sensor) and the rear bumper of the preceding vehicle should be approximately 3 m (9.84 ft.).

·

The distance between the pre-crash safety city sensor (laser sensor) and the front bumper of this vehicle is 1.53 m (5.02 ft.).

·

The distance between the pre-crash safety city sensor (laser sensor) and the preceding vehicle is displayed in the Data List.

·

Do not use a modified car as a preceding vehicle.



b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / PCS/LDA/RSA/LVN / Data List.


f.

Read the Data List according to the display on the GTS.

PCS/LDA/RSA/LVN
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Lidar Detect Target Distance Displays distance of the highest priority object which is detected by Lidar / 0 to 51 m. Distance between the vehicle and a preceding vehicle
·

When no preceding vehicle is detected, "0 m" (0 ft.) is displayed

·

Displays the distance between the pre-crash safety city sensor (laser sensor) and a preceding vehicle.



HINT:

If "0 m" (0 ft.) is displayed, the pre-crash safety city sensor (laser sensor) is malfunctioning.



Result
Result Proceed to
Distance displayed is within 3.0 m (9.84 ft.) +/- 0.5 m (1.64 ft.) A
Distance displayed is not within 3.0 m (9.84 ft.) +/- 0.5 m (1.64 ft.) B


A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE PRE-CRASH SAFETY CITY SENSOR