When a new pre-crash safety city sensor is installed, it receives and stores vehicle destination information from the main body ECU (multiplex network body ECU). If the pre-crash safety city sensor cannot receive vehicle destination information from the main body ECU (multiplex network body ECU) and vehicle information is not stored, DTC C1AAA is output.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1AAA | All of the following conditions are met: -
The battery voltage is 10 V or more. -
The vehicle is being driven at 50 km/h (32 mph) or more. -
Destination information has not been stored in the pre-crash safety city sensor. |
·
Main body ECU (multiplex network body ECU) ·
Pre-crash safety city sensor |
When replacing the pre-crash safety city sensor, replace it with a new one and be sure to initialize the settings. If a pre-crash safety city sensor which was installed to another vehicle is used, the information stored in the pre-crash safety city sensor will not match the information from the vehicle and, as a result, a DTC may be stored.
If the pre-crash safety city sensor has been replaced, or the windshield glass has been replaced or removed/installed, be sure to perform Pre-crash Safety City Sensor Learning.
Adjustment (One time recognition)
Click hereVehicle Interior>PRE-CRASH SAFETY>FRONT SENSOR>ADJUSTMENT (ONE TIME RECOGNITION)
Adjustment (Sequential recognition)
Click hereVehicle Interior>PRE-CRASH SAFETY>FRONT SENSOR>ADJUSTMENT (SEQUENTIAL RECOGNITION)
First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed to troubleshooting (See page Engine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).
Clear the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR).
Turn the ignition switch to ON and wait for approximately 1 minute.
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1AAA is not output | A |
| DTC C1AAA is output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
Replace the main body ECU (multiplex network body ECU) with a new one (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).
NEXT
Clear the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR).
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1AAA is not output | A |
| DTC C1AAA is output | B |
A
B