The skid control ECU (brake actuator assembly) is connected to the combination meter via CAN communication.
Refer to ABS Warning Light Remains ON (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Built-in Type Yaw Rate Sensor)>ABS Warning Light Remains ON).
When replacing the skid control ECU, perform zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Built-in Type Yaw Rate Sensor)>CALIBRATION).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Check if CAN communication system DTCs are output.
w/o Toyota Safety Sense
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(w/o Toyota Safety Sense)>DIAGNOSIS SYSTEM
w/ Toyota Safety Sense
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(w/ Toyota Safety Sense)>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output (w/o Toyota Safety Sense) | B |
| DTC is output (w/ Toyota Safety Sense) | C |
A
B
C
Disconnect the skid control ECU connector.
Turn the ignition switch to ON.
Check that the ABS warning light comes on.
| Result | Proceed to |
|---|---|
| NG | A |
| OK | B |
Reconnect the skid control ECU connector.
A
B
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| ABS Warning Light | ABS warning light/OFF or ON | OFF: Warning light off
ON: Warning light on |
- |
When performing the ABS Warning Light Active Test, check ABS Warning Light in the Data List.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| ABS Warning Light | ABS warning light | Warning light OFF/ON | Observe combination meter
[Vehicle condition] Vehicle stopped |
| Result | Proceed to | |
|---|---|---|
| Data List Display | Data List Display when Performing Active Test ON/OFF Operation | |
| ON | Changes between ON and OFF | A |
| Does not change between ON and OFF | B | |
| OFF | Changes between ON and OFF | A |
| Does not change between ON and OFF | B | |
A
B