Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM(for Built-in Type Yaw Rate Sensor) › from 2017.01
RM19S0E _54 Brake _051475 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0248227 VEHICLE STABILITY CONTROL SYSTEM(for Built-in Type Yaw Rate Sensor) J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(for Built-in Type Yaw Rate Sensor)  Slip Indicator Light does not Come ON  


DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter via CAN communication.

The Slip indicator light blinks during VSC, TRC operation.

If any of the following is detected, the Slip indicator light remains on:

·

The skid control ECU (brake actuator assembly) connectors are disconnected from the brake actuator (skid control ECU).

·

There is a malfunction in the skid control ECU (brake actuator assembly) internal circuit.

·

There is an open in the harness between the combination meter and the skid control ECU (brake actuator assembly).

·

The VSC, TRC control system is defective.

HINT:

In some cases, the GTS cannot be used when the skid control ECU (brake actuator assembly) is abnormal.



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the brake actuator assembly, perform zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Built-in Type Yaw Rate Sensor)>CALIBRATION).

·

Inspect the fuses for circuits related to this system before performing the following inspection procedure.



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM

Result
Result Proceed to
DTC is not output A
DTC is output (w/o Toyota Safety Sense) B
DTC is output (w/ Toyota Safety Sense) C


A

2.CHECK SLIP INDICATOR LIGHT

B

C

2.CHECK SLIP INDICATOR LIGHT
a.

Disconnect the skid control ECU connector.


b.

Turn the ignition switch to ON.


c.

Check that the Slip indicator light comes on.



OK

NG

3.READ VALUE USING GTS (SLIP INDICATOR LIGHT)
3.READ VALUE USING GTS (SLIP INDICATOR LIGHT)
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / ABS/VSC/TRC / Data List.


f.

According to the display on the GTS, read the Data List.

ABS/VSC/TRC
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Slip Indicator Light SLIP indicator light/OFF or ON OFF: Indicator light off
ON: Indicator light on
-


g.

When performing the Slip Indicator Light Active Test, check Slip Indicator Light in the Data List.


ABS/VSC/TRC
Tester Display Test Part Control Range Diagnostic Note
Slip Indicator Light Slip indicator light Indicator light OFF/ON Observe combination meter
[Vehicle condition]
Vehicle stopped

Result
Result Proceed to
Data List Display Data List Display when Performing Active Test ON/OFF Operation
ON Changes between ON and OFF A
Does not change between ON and OFF B
OFF Changes between ON and OFF A
Does not change between ON and OFF B


A

REPLACE COMBINATION METER ASSEMBLY

B