Home › Vehicle Exterior › WINDOW / GLASS › WINDSHIELD GLASS › 2017.01–2018.06
RM19S0E _59 Vehicle Exterior _051501 WINDOW / GLASS _0248384 WINDSHIELD GLASS A

WINDOW / GLASS  WINDSHIELD GLASS  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

When replacing the windshield glass of a vehicle equipped with a pre-crash safety city sensor, make sure to use a Toyota genuine part. If a non-Toyota genuine part is used, the pre-crash safety city sensor may not be able to be installed due to a missing bracket or the pre-crash safety system may not operate properly due to a difference in the transmissivity of the windshield glass or the shape of the black ceramic border.


PROCEDURE

Hide 1.REMOVE WINDSHIELD WIPER MOTOR AND LINK

Hide 88181 2.REMOVE PRE-CRASH SAFETY CITY SENSOR (w/ Pre-crash Safety System)

Hide 87810 3.REMOVE INNER REAR VIEW MIRROR ASSEMBLY

Hide 4.REMOVE ROOF HEADLINING ASSEMBLY (for 5 Door)

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for 5 Door)>REMOVAL

HINT:

It is not necessary to remove the roof headlining completely. Slightly lower the front section of the roof headlining.


Hide 5.REMOVE ROOF HEADLINING ASSEMBLY (for 3 Door)

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for 3 Door)>REMOVAL

HINT:

It is not necessary to remove the roof headlining completely. Slightly lower the front section of the roof headlining.


Hide 75533E 6.REMOVE WINDSHIELD OUTSIDE MOULDING

a.
B292035C02
0.855,0.234 1.055,0.401 0.200,0.167 10 *a 1.617,0.394 1.054,0.344 1.054,0.344 1.243,0.593 false
*a Cut


Using a knife, cut off the windshield outside moulding, as shown in the illustration.

NOTICE:

Do not damage the vehicle body with the knife.



Hide 56111 7.REMOVE WINDSHIELD GLASS

a.
B292036C03
1.958,1.198 2.302,0.938 false 2.333,0.823 2.542,0.99 0.208,0.167 10 false *a
*a Protective tape


Apply protective tape to the installation area on the windshield glass on the vehicle body.


b.
B292037C07
0.755,1.722 0.958,1.887 0.203,0.164 10 *a 1.279,2.117 0.944,1.842 0.944,1.842 1.222,2.208 false
*a Mark


Place matchmarks on the windshield glass and vehicle body on the locations indicated in the illustration.

HINT:

Matchmarks do not need to be placed if the windshield glass is not going to be reused.



c.
B272660C04
1.99,1.146 1.75,1.521 false 1.99,0.969 2.156,1.146 0.167,0.177 10 false *a
*a Piano wire


Pass a piano wire between the vehicle body and glass from the interior.


d.

Tie both wire ends to wooden blocks or similar objects.


e.

Cut off the adhesive by pulling the piano wire around the windshield glass.

NOTICE:
·

When separating the windshield glass, take care not to damage the paint or the interior and exterior ornaments.

·

To prevent the safety pad from being scratched when removing the windshield glass, place a plastic sheet between the piano wire and safety pad.




f.

Using suction cups, disengage the windshield glass stopper and remove the windshield glass.

B292038C03
1.74,0.979 1.844,1.042 false 5.01,1.031 4.844,1.073 false 4.865,0.813 4.583,0.854 false 0.667,0.073 0.917,0.26 0.25,0.188 10 false *A 3.719,0.073 3.969,0.26 0.25,0.188 10 false *B 4.438,0.781 4.646,0.958 0.208,0.177 10 false *1 4.688,1.01 4.896,1.188 0.208,0.177 10 false *2 1.854,0.979 2.063,1.156 0.208,0.177 10 false *1
*A for 1 - piece Type *B for 2 - piece Type
*1 No. 1 Windshield Glass Stopper *2 No. 2 Windshield Glass Stopper


NOTICE:
·

Be careful not to drop the windshield glass.

·

Leave as much adhesive on the vehicle body as possible when removing the windshield glass.

·

To prevent the windshield glass from dropping when performing this operation, be sure to hold the windshield glass using suction cups.

·

There are windshield glass stopper and No. 1 windshield glass stoppers on the windshield glass. Be careful not to damage the windshield glass when cutting off the adhesive.



HINT:

Depending on vehicles, 1-piece or 2-piece type stoppers are used.



Hide 56117A 8.REMOVE WINDOW GLASS ADHESIVE DAM

a.

Using a scraper, remove the windshield glass adhesive dam.

NOTICE:
·

Be careful not to damage the windshield glass.

·

Be sure to replace the window glass adhesive dam with a new one.




Hide 56115A 9.REMOVE NO. 1 WINDSHIELD GLASS STOPPER (for 1-piece Type)

a.

Using a scraper, remove the 2 No. 1 windshield glass stoppers.

NOTICE:
·

Be careful not to damage the windshield glass.

·

Be sure to replace the windshield glass stoppers with new ones.




Hide 56116C 10.REMOVE NO. 2 WINDSHIELD GLASS STOPPER (for 2-piece Type)

a.

Using a scraper, remove the 2 No. 2 windshield glass stoppers.

NOTICE:
·

Be careful not to damage the windshield glass.

·

Be sure to replace the windshield glass stoppers with new ones.




Hide 56115A 11.REMOVE NO. 1 WINDSHIELD GLASS STOPPER (for 2-piece Type)

a.
B292039C02
1.438,0.729 1.135,0.844 false 0.969,0.771 1.167,0.958 0.198,0.188 10 false *1
*1 No. 1 Windshield Glass Stopper


Remove the 2 No. 1 windshield glass stoppers.

NOTICE:

Be sure to replace the windshield glass stoppers with new ones.