DTC C1271 Low Output Signal of Front Speed Sensor RH (Test Mode DTC) |
DTC C1272 Low Output Signal of Front Speed Sensor LH (Test Mode DTC) |
DTC C1401 Front Speed Sensor RH Malfunction |
DTC C1402 Front Speed Sensor LH Malfunction |

| *1 | Speed Sensor | *2 | Speed Sensor Rotor |
| *a | Waveform (Reference): Between Speed Sensor (-) and Body Ground | *b | Low speed |
| *c | High speed | - | - |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1401 C1402 | Any of the following is detected:
|
|
| DTC No. | DTC Detection Condition | Trouble Area |
| C1271 C1272 | Detected only during Test Mode. |
|

| 1.CHECK FRONT SPEED SENSOR INSTALLATION |
Turn the ignition switch off.
![]() |
Check the speed sensor installation.
| *a | Normal |
| *b | Abnormal |
| *c | Clearance |
|
| ||||
| OK | |
| 2.INSPECT FRONT SPEED SENSOR TIP |
Remove the front speed sensor (Click here).
Check the speed sensor tip.
Reinstall the front speed sensor (Click here)
|
| ||||
| OK | |
| 3.INSPECT FRONT SPEED SENSOR ROTOR |
Remove the front axle hub sub-assembly (Click here).
Check the speed sensor rotor.
Reinstall the front axle hub assembly (Click here).
|
| ||||
| OK | |
| 4.READ VALUE USING TECHSTREAM (FRONT SPEED SENSOR) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| FR Wheel Speed | FR wheel speed sensor reading / min.: 0 km/h (0 mph), max.: 326 km/h (202 mph) | Vehicle stopped: 0 km/h | When driving at constant speed: No large fluctuations |
| FL Wheel Speed | FL wheel speed sensor reading /min.: 0 km/h (0 mph), max.: 326 km/h (202 mph) | Vehicle stopped: 0 km/h | When driving at constant speed: No large fluctuations |
Check that there is no difference between the speed value output from the speed sensor displayed on the Techstream and the speed value displayed on the speedometer when driving the vehicle.
| Result | Proceed to |
| NG | A |
| OK | B |
|
| ||||
| A | |
| 5.REPLACE FRONT SPEED SENSOR |
Turn the ignition switch off.
Replace the front speed sensor (Click here).
| NEXT | |
| 6.RECONFIRM DTC |
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 40 km/h (25 mph) or more for at least 60 seconds.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTCs C1401 and C1402 are not output | A |
| DTCs C1401 and/or C1402 are output | B |
|
| ||||
| A | ||
| ||