DTC C1581/81 Assist Map Un-Writing |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1581/81 | Assist map not written in power steering ECU |
|
| 1.PERFORM ASSIST MAP WRITING |
Connect a Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Set the Techstream to Test Mode (select "Signal Check").
Wait for 7 seconds or more.
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 2.CHECK CAN COMMUNICATION SYSTEM |
Check for DTCs of the CAN communication system (Click here).
|
| ||||
| OK | |
| 3.CHECK ECM |
Check if a qualified ECM is installed.
|
| ||||
| OK | |
| 4.CHECK SKID CONTROL ECU |
Check if a qualified skid control ECU is installed.
|
| ||||
| OK | ||
| ||