Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM (for Hatchback)

CRUISE CONTROL SYSTEM (for Hatchback) > Cruise Control Switch Circuit


DESCRIPTION

This circuit sends a signal to the ECM depending on the cruise control main switch condition. The battery supplies positive (+) battery voltage to the cruise control main switch. Terminal 60 (CCS) of the ECM receives the voltage which varies according to the switch condition.

WIRING DIAGRAM


B291387E01


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (CRUISE CONTROL MAIN SWITCH)
  1. Using the Techstream, read the Data List (Click here).

    Cruise Control 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Main SW M-CPU
    Cruise control main switch (Main CPU) / OFF or ON
    OFF: Cruise control main switch off
    ON: Cruise control main switch on
    -
    Cancel Switch
    CANCEL switch signal / OFF or ON
    OFF: CANCEL switch off
    ON: CANCEL switch on
    -
    SET/COAST Switch
    -SET switch signal / OFF or ON
    OFF: -SET switch off
    ON: -SET switch on
    -
    RES/ACC Switch
    +RES switch signal / OFF or ON
    OFF: +RES switch off
    ON: +RES switch on
    -

    OK:
    The display is as specified in the normal condition column.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT CRUISE CONTROL MAIN SWITCH
  1. Inspect the cruise control main switch (Click here).



NG
REPLACE CRUISE CONTROL MAIN SWITCH (Click here)
OK


3.INSPECT CRUISE CONTROL SWITCH WIRE


    E216575E04
  1. Remove the cruise control switch wire.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    V13-3 (CCS) - 3 (CCS)
    Always
    Below 1 Ω
    V13-4 (ECC) - 1 (ECC)

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Spiral Cable Sub-assembly)
    *b
    Front view of wire harness connector
    (to Cruise Control Switch)



NG
REPLACE CRUISE CONTROL SWITCH WIRE
OK


4.INSPECT SPIRAL CABLE SUB-ASSEMBLY
  1. Inspect the spiral cable sub-assembly (Click here).



NG
REPLACE SPIRAL CABLE SUB-ASSEMBLY (Click here)
OK


5.CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - ECM AND BODY GROUND)
  1. Disconnect the D103 spiral cable sub-assembly connector.

  1. Disconnect the A72 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D103-1 (CCS) - A72-60 (CCS)
    Always
    Below 1 Ω
    D103-2 (ECC) - Body ground
    D103-1 (CCS) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)