Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER (for Hatchback)

TIRE PRESSURE WARNING RECEIVER (for Hatchback) > INSTALLATION



1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER
  1. Connect the connector to the tire pressure warning ECU and receiver.

  1. Engage the 2 tabs into the holes to temporarily install the tire pressure warning ECU and receiver.

  1. Install the bolt to install the tire pressure warning ECU and receiver.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



2. INSTALL ROOF SIDE INNER GARNISH LH (for 5 Door)
(Click here)


3. INSTALL ROOF SIDE INNER GARNISH LH (for 3 Door)
(Click here)


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



5. REGISTER TRANSMITTER ID
(Click here)


6. INSPECT TIRE PRESSURE WARNING SYSTEM
(Click here)


7. PERFORM INITIALIZATION
(Click here)


8. INSPECT SRS WARNING LIGHT
w/ VSC: (Click here)
w/o VSC: (Click here)