Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK(for TMT Made) › 2013.08–2017.10
RM30M0E _58 Vehicle Interior _017110 DOOR LOCK _0087448 FRONT DOOR LOCK(for TMT Made) A

DOOR LOCK  FRONT DOOR LOCK(for TMT Made)  INSTALLATION  


PROCEDURE

Hide 69720B 1.INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

a.

Engage the guide and install the front door lock remote control cable assembly to the front door lock assembly.


Hide 69760C 2.INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY

a.

Engage the guide and install the front door inside locking cable assembly to the front door lock assembly.


b.
B347075

Engage the 5 claws and close the cover in the direction indicated by the arrow as shown in the illustration.


Hide 69320 3.INSTALL FRONT DOOR LOCK ASSEMBLY

NOTICE:
·

When reusing the removed front door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

·

Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.

·

Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may result in a malfunction of the front door lock assembly.



a.

Apply MP grease to the sliding parts of the front door lock assembly.


b.

When reusing the front door lock assembly:

i.

Install a new door lock wiring harness seal to the front door lock assembly.



c.
B347076

Insert the front door lock open rod to the front door lock assembly.


d.

Make sure that the front door lock open rod is securely connected to the front door lock assembly.


e.

Using a T30 "TORX" socket wrench, install the front door lock assembly with the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


f.

w/ Power Door Lock:

i.

Connect the connector.



Hide 69217F 4.INSTALL FRONT DOOR OUTSIDE HANDLE COVER (w/ Lock Cylinder)

Hide 67404F 5.INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

Hide 68151D 6.INSTALL FRONT DOOR GLASS RUN

Hide 68102 7.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

Hide 67832 8.INSTALL FRONT DOOR SERVICE HOLE COVER

Hide 68172A 9.INSTALL FRONT DOOR GLASS INNER WEATHERSTRIP

Hide 67602 10.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74232 11.INSTALL FRONT ARMREST BASE UPPER PANEL (w/ Power Window)

Hide 74232 12.INSTALL FRONT ARMREST BASE UPPER PANEL (w/o Power Window)

Hide 69260 13.INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

Hide 67492A 14.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 15.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

Hide 16.INITIALIZE POWER WINDOW CONTROL SYSTEM (for Driver Side with Power Window)

Hide 17.CHECK POWER WINDOW CONTROL SYSTEM (for Driver Side with Power Window)