1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
81150
2.REMOVE HEADLIGHT ASSEMBLY LH
81150
3.REMOVE HEADLIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
89173
4.REMOVE FRONT AIRBAG SENSOR (w/ Airbag System)
53510
5.REMOVE HOOD LOCK ASSEMBLY (for LHD)
53510
6.REMOVE HOOD LOCK ASSEMBLY (for RHD)
w/ Engine Hood Courtesy Switch:
Click hereVehicle Exterior>DOOR / HATCH>HOOD LOCK CONTROL CABLE ASSEMBLY(for RHD)>REMOVAL
w/o Engine Hood Courtesy Switch:
Click hereVehicle Exterior>DOOR / HATCH>HOOD LOCK CONTROL CABLE ASSEMBLY(for RHD)>REMOVAL
53215B
7.REMOVE HOOD LOCK SUPPORT (for 1NZ-FE)
53215B
8.REMOVE HOOD LOCK SUPPORT (for 2NZ-FE)
88891H
9.REMOVE NO. 1 COOLER COVER (w/ No. 1 Cooler Cover)
53216A
10.REMOVE UPPER RADIATOR SUPPORT (for 1NZ-FE)
53216A
11.REMOVE UPPER RADIATOR SUPPORT (for 2NZ-FE)
for LHD:
Click hereEngine / Hybrid System>2NZ-FE COOLING>RADIATOR>REMOVAL
for RHD:
Click hereEngine / Hybrid System>2NZ-FE COOLING>RADIATOR>REMOVAL
88711
12.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the cooler condenser assembly.
Remove the O-ring from the No. 1 cooler refrigerant discharge hose.
Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.
88706A
13.DISCONNECT LIQUID TUBE SUB-ASSEMBLY A
Remove the bolt and disconnect the liquid tube sub-assembly A from the cooler condenser assembly.
Remove the O-ring from the liquid tube sub-assembly A.
Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.
88460
14.REMOVE COOLER CONDENSER ASSEMBLY
Disengage the 2 claws.
Do not damage the cooler condenser assembly or radiator assembly when removing the cooler condenser assembly.
Disengage the 2 guides and remove the cooler condenser assembly as shown in the illustration.