1.INSTALL RADIATOR DRAIN COCK PLUG
Install the radiator drain cock plug to the radiator assembly.
Replace the O-ring if it is damaged.
16535
2.INSTALL LOWER RADIATOR SUPPORT
Install the 2 lower radiator supports to the radiator assembly.
16523A
3.INSTALL RADIATOR SUPPORT CUSHION
Install the 2 radiator support cushions to the radiator assembly.
16711
4.INSTALL FAN SHROUD
Engage the 2 guides and 2 claws to install the fan shroud to the radiator assembly.
16400
5.INSTALL RADIATOR ASSEMBLY (w/ Cooler System)
Install the radiator assembly together with fan shroud to the vehicle.
Do not apply excessive force to the cooler condenser assembly or piping when installing the radiator assembly.
Engage the 2 guides and 2 claws to install the cooler condenser assembly to the radiator assembly.
While tilting the cooler condenser assembly toward the front of the vehicle, install the cooler condenser assembly to the radiator assembly.
Engage the 3 clamps to connect the wire harness to the fan shroud.
Connect the cooling fan motor connector.
16400
6.INSTALL RADIATOR ASSEMBLY (w/o Cooler System)
Install the radiator assembly together with fan shroud to the vehicle.
Engage the 3 clamps to connect the wire harness to the fan shroud.
Connect the cooling fan motor connector.
32941
7.CONNECT INLET NO. 1 OIL COOLER HOSE (for Automatic Transaxle)
| *a | View A |
| *b | Top of Vehicle |
| *c | Right Side of Vehicle |
Connect the inlet No. 1 oil cooler hose to the radiator assembly with the hose clip.
Perform the installation with the hose clip at the correct angle.
32942
8.CONNECT OUTLET NO. 1 OIL COOLER HOSE (for Automatic Transaxle)
| *a | View A |
| *b | Top of Vehicle |
| *c | Right Side of Vehicle |
Connect the outlet No. 1 oil cooler hose to the radiator assembly with the hose clip.
Perform the installation with the hose clip at the correct angle.
16572D
9.CONNECT NO. 2 RADIATOR HOSE
| *a | View A |
| *b | Hose Paint Mark |
| *c | Top of Vehicle |
| *d | Left Side of Vehicle |
Connect the No. 2 radiator hose to the radiator assembly with the hose clip.
Perform the installation with the No. 2 radiator hose and hose clip at the correct angle.
16573B
10.CONNECT NO. 3 RADIATOR HOSE
| *a | View A |
| *b | Hose Paint Mark |
| *c | Top of Vehicle |
| *d | Left Side of Vehicle |
Connect the No. 3 radiator hose to the radiator assembly with the hose clip.
Perform the installation with the No. 3 radiator hose and hose clip at the correct angle.
11.CONNECT RADIATOR RESERVOIR TANK HOSE
Connect the radiator reservoir tank hose to the water filler sub-assembly.
16750
12.INSTALL FAN SHROUD VENTILATION DUCT ASSEMBLY (w/ Fan Shroud Ventilation Duct)
Engage the 2 guides and 2 claws to install the fan shroud ventilation duct assembly to the radiator assembly.
53216A
13.INSTALL UPPER RADIATOR SUPPORT (for LHD)
Install the upper radiator support to the radiator support assembly with the 4 bolts.
Connect the low pitched horn assembly connector.
Engage the 2 clamps to connect the wire harness to the upper radiator support.
Engage the clamp to connect the hood lock control cable assembly to the upper radiator support.
53216A
14.INSTALL UPPER RADIATOR SUPPORT (for RHD)
Install the upper radiator support to the radiator support assembly with the 4 bolts.
Connect the low pitched horn assembly connector.
Engage the 2 clamps to connect the wire harness to the upper radiator support.
Engage the clamp to connect the hood lock control cable assembly to the upper radiator support.
88891H
15.INSTALL NO. 1 COOLER COVER (w/o Fan Shroud Ventilation Duct)
53215B
16.INSTALL HOOD LOCK SUPPORT
Install the hood lock support to the radiator support assembly with the 2 bolts.
Engage the clamp to connect the wire harness to the hood lock support.
53510
17.INSTALL HOOD LOCK ASSEMBLY (for LHD)
53510
18.INSTALL HOOD LOCK ASSEMBLY (for RHD)
w/ Engine Hood Courtesy Switch
Click hereVehicle Exterior>DOOR / HATCH>HOOD LOCK CONTROL CABLE ASSEMBLY(for RHD)>INSTALLATION
w/o Engine Hood Courtesy Switch
Click hereVehicle Exterior>DOOR / HATCH>HOOD LOCK CONTROL CABLE ASSEMBLY(for RHD)>INSTALLATION
89173
19.INSTALL FRONT AIRBAG SENSOR (w/ Airbag System)
81150
20.INSTALL HEADLIGHT ASSEMBLY LH
81150
21.INSTALL HEADLIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
22.ADD ENGINE COOLANT
23.INSPECT FOR COOLANT LEAK
24.ADJUST HOOD SUB-ASSEMBLY