Use the same procedure for both the LH and RH sides.
The procedure described below is for the LH side.
Perform these procedures with the rear door glass sub-assembly in the fully opened position.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (for Hatchback).
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
69260E
3.REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
| *a | Protective Tape |
Insert a clip remover with its shaft wrapped in protective tape between the window regulator handle plate and the rear door window regulator handle assembly.
Turn the rear door window regulator handle assembly with the clip remover inserted, as shown in the illustration.
Remove the shaft snap ring and the rear door window regulator handle assembly.
Remove the window regulator handle plate.
74272A
4.REMOVE REAR DOOR ARMREST BASE UPPER PANEL (w/o Power Window)
Using a moulding remover, disengage the 5 claws and remove the rear door armrest base upper panel.
74272A
5.REMOVE REAR DOOR ARMREST BASE UPPER PANEL (w/ Power Window)
Using a moulding remover, disengage the 7 claws.
Disconnect the connector and remove the rear door armrest base upper panel.
67604
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw and open the door inside handle bezel plug.
Remove the 3 screws.
Disengage the 7 clips.
Disengage the guide and the 6 claws.
| *1 | Rear Door Inside Locking Cable Assembly |
| *2 | Rear Door Lock Remote Control Cable Assembly |
Disengage the 2 guides, disconnect the rear door lock remote control cable assembly and the rear door inside locking cable assembly and remove the rear door trim board sub-assembly.
69206C
7.REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY
Disengage the 4 guides and remove the rear door inside handle sub-assembly from the rear door trim board sub-assembly.
86160B
8.REMOVE REAR SPEAKER ASSEMBLY (w/ Rear Speaker)
68230C
9.REMOVE REAR DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY
75762A
10.REMOVE REAR DOOR WINDOW FRAME FRONT MOULDING
75924
11.REMOVE NO. 2 BLACK OUT TAPE (for Sedan)
w/ Black Out Tape
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>BLACK OUT TAPE(for Rear Door)>REMOVAL
75924
12.REMOVE NO. 2 BLACK OUT TAPE (for Hatchback)
75742
13.REMOVE REAR DOOR OUTSIDE MOULDING (for Hatchback)
68174A
14.REMOVE REAR DOOR GLASS INNER WEATHERSTRIP
Remove the rear door glass inner weatherstrip.
68152C
15.REMOVE REAR DOOR GLASS RUN
Remove the rear door glass run.
67674A
16.REMOVE REAR DOOR FRAME GARNISH
Disengage the clamp and remove the rear door frame garnish.
67842E
17.REMOVE REAR DOOR SERVICE HOLE COVER
Disconnect each connector.
Remove the rear door service hole cover.
Remove any butyl tape remaining on the rear door panel.
67408H
18.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
Remove the screw.
Peel back the rear door weatherstrip to remove the screw.
When the rear door window division bar sub-assembly is removed, do not allow the rear door quarter window glass to fall.
Remove the 2 bolts and rear door window division bar sub-assembly.
68104
19.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
Separate the rear door glass sub-assembly from the rear door window regulator assembly as shown in the illustration.
Do not damage the rear door glass sub-assembly.
Remove the rear door glass sub-assembly in the direction indicated by the arrow as shown in the illustration.
Do not damage the rear door glass sub-assembly.
69840A
20.REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY (w/ Power Window)
| *a | Temporary Bolt |
Disconnect the connector.
Loosen the temporary bolt.
Do not remove the temporary bolt. If the temporary bolt is removed, the rear door window regulator assembly may fall and cause damage.
Remove the 3 bolts and the rear door window regulator assembly.
Remove the temporary bolt from the rear door window regulator assembly.
69840A
21.REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY (w/o Power Window)
Remove the 3 bolts and the rear door window regulator assembly.
68124B
22.REMOVE REAR DOOR QUARTER WINDOW GLASS
Remove the rear door quarter window glass with rear door quarter window weatherstrip in the direction indicated by the arrow as shown in the illustration.
68189
23.REMOVE REAR DOOR QUARTER WINDOW WEATHERSTRIP
Remove the rear door quarter window weatherstrip from the rear door quarter window glass.
24.REMOVE HOLE PLUG (for TMMIN Made)
w/o Power Door Lock
Remove the hole plug.
69340
25.REMOVE REAR DOOR LOCK ASSEMBLY (for TMT Made)
69340
26.REMOVE REAR DOOR LOCK ASSEMBLY (for TMMIN Made)
w/ Power Door Lock
Click hereVehicle Interior>DOOR LOCK>REAR DOOR LOCK(for TMMIN Made)>REMOVAL
w/o Power Door Lock
Click hereVehicle Interior>DOOR LOCK>REAR DOOR LOCK(for TMMIN Made)>REMOVAL
69227L
27.REMOVE REAR DOOR OUTSIDE HANDLE COVER
Using a T30 "TORX" socket wrench, loosen the screw.
Disengage the 2 claws and the 2 guides, and remove the rear door outside handle cover.
69240
28.REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY
Remove the rear door outside handle assembly in the direction indicated by the arrow as shown in the illustration.
69241G
29.REMOVE REAR DOOR OUTSIDE HANDLE FRONT PAD
Using a T30 "TORX" socket wrench, loosen the screw.
Disengage the 2 claws and remove the rear door outside handle front pad.
69242G
30.REMOVE REAR DOOR OUTSIDE HANDLE REAR PAD
Disengage the 2 claws and remove the rear door outside handle rear pad.
69204A
31.REMOVE REAR DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY
| *a | Grommet |
| *b | Guide |
Disengage the grommet and the guide, and remove the rear door outside handle frame sub-assembly in the direction indicated by the arrow as shown in the illustration.
68630
32.REMOVE REAR DOOR CHECK ASSEMBLY
Remove the 3 bolts and the rear door check assembly.
67872
33.REMOVE REAR DOOR WEATHERSTRIP
Using a clip remover, disengage the 16 clips and the clamp, and remove the rear door weatherstrip.