13511
1.REMOVE CAMSHAFT
17118
2.REMOVE MANIFOLD STAY
25051
3.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY
23814B
4.REMOVE FUEL DELIVERY PIPE
23891
5.REMOVE FUEL DELIVERY SPACER
23291
6.REMOVE INJECTOR VIBRATION INSULATOR
Remove the 4 injector vibration insulators from the cylinder head sub-assembly.
16267
7.DISCONNECT NO. 3 WATER BY-PASS HOSE
16264
8.DISCONNECT NO. 2 WATER BY-PASS HOSE
22030
9.REMOVE INTAKE MANIFOLD WITH THROTTLE BODY WITH MOTOR ASSEMBLY
11101
10.REMOVE CYLINDER HEAD SUB-ASSEMBLY
Using a 10 mm bi-hexagon wrench, uniformly loosen and remove the 10 cylinder head set bolts and 10 plate washers in several steps in the sequence shown in the illustration.
Removing the cylinder head set bolts in the wrong order may cause warpage or cracking of the cylinder head sub-assembly.
Remove the cylinder head sub-assembly from the cylinder block sub-assembly.
11115
11.REMOVE CYLINDER HEAD GASKET
Remove the cylinder head gasket from the cylinder block sub-assembly.
11101A
12.INSPECT CYLINDER HEAD SET BOLT