1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2.REMOVE FRONT WHEELS
3.SECURE STEERING WHEEL
Secure the steering wheel with the seat belt in order to prevent it from rotating.
This operation is useful to prevent damage to the spiral cable.
45259A
4.REMOVE COLUMN HOLE COVER SILENCER SHEET
45209
5.SEPARATE STEERING SLIDING YOKE SUB-ASSEMBLY
45025D
6.SEPARATE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
Disengage clip A and clip B from the body and separate the No. 1 steering column hole cover sub-assembly.
Do not damage clip B.
51451A
7.REMOVE CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)
51405A
8.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)
48819A
9.REMOVE FRONT STABILIZER BOLT LH
48819A
10.REMOVE FRONT STABILIZER BOLT RH
Use the same procedure described for the LH side.
45047
11.SEPARATE TIE ROD END SUB-ASSEMBLY LH
45046
12.SEPARATE TIE ROD END SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
48069
13.SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
48068
14.SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
57533B
15.REMOVE FRONT FLOOR CENTER BRACE (for 1NR-FE)
57533B
16.REMOVE FRONT FLOOR CENTER BRACE (for 2NR-FE)
17410
17.REMOVE FRONT EXHAUST PIPE ASSEMBLY (for 1NR-FE)
17410
18.REMOVE FRONT EXHAUST PIPE ASSEMBLY (for 2NR-FE)
51201
19.REMOVE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY
Remove the bolt and separate the engine moving control rod.
| *a | Plate Lift Attachment |
| *b | Engine Lifter |
|
Front of the Vehicle |
|
Attachment Placement Positions |
Place wooden blocks or plate lift attachments in the positions shown in the illustration and set an engine lifter underneath the front suspension crossmember sub-assembly.
Place the wooden blocks or plate lift attachments so that the front suspension crossmember sub-assembly is level.
As the front suspension crossmember sub-assembly is very heavy, be sure to support it securely.
Remove the 6 bolts and front suspension crossmember sub-assembly.
When lowering the front suspension crossmember sub-assembly, be careful not to damage the vehicle body or other components installed on the vehicle.
45025D
20.REMOVE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
21.REMOVE STEERING LINK ASSEMBLY
48829A
22.REMOVE FRONT NO. 1 STABILIZER BRACKET LH
48824A
23.REMOVE FRONT NO. 1 STABILIZER BRACKET RH
Use the same procedure described for the LH side.
48811
24.REMOVE FRONT STABILIZER BAR
48069
25.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
Remove the bolt and front lower No. 1 suspension arm sub-assembly LH from the front suspension crossmember sub-assembly.
48068
26.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
12363A
27.REMOVE ENGINE MOVING CONTROL ROD (for Manual Transaxle)
Remove the bolt and engine moving control rod from the front suspension crossmember sub-assembly.
12363A
28.REMOVE ENGINE MOVING CONTROL ROD (for Automatic Transaxle and CVT)
Remove the bolt and engine moving control rod from the front suspension crossmember sub-assembly.