Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
2.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
45186
4.REMOVE NO. 2 STEERING WHEEL LOWER COVER
45130
5.REMOVE HORN BUTTON ASSEMBLY (w/ Airbag System)
45130
6.REMOVE HORN BUTTON ASSEMBLY (w/o Airbag System)
45100
7.REMOVE STEERING WHEEL ASSEMBLY
45289A
8.REMOVE STEERING COLUMN COVER SUPPORT (w/ Smart Entry and Start System)
Disengage the 4 claws to remove the steering column cover support.
45287
9.REMOVE LOWER STEERING COLUMN COVER
Remove the 3 screws.
Release the tilt lever.
Disengage the 3 claws to remove the lower steering column cover.
45286B
10.REMOVE UPPER STEERING COLUMN COVER
Disengage the claw to remove the upper steering column cover.
11.REMOVE COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE
Disconnect all the connectors from the combination switch assembly with spiral cable.
| *1 | Clamp |
| *a | Claw |
Use pliers to hold the clamp and raise the claw with a screwdriver. Remove the combination switch assembly with spiral cable from the steering column assembly.
55606
12.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55432B
13.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (for LHD)
55432B
14.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (for RHD)
45259A
15.REMOVE COLUMN HOLE COVER SILENCER SHEET
Fold back the floor carpet.
Remove the 2 clips and column hole cover silencer sheet.
45209
16.SEPARATE STEERING SLIDING YOKE SUB-ASSEMBLY
| *a | Matchmark |
Put matchmarks on the steering sliding yoke sub-assembly and steering link assembly.
Loosen bolt A.
Remove bolt B to separate the steering sliding yoke sub-assembly from the steering link assembly.
55106
17.REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY (for LHD)
55106
18.REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY (for RHD)
89650
19.REMOVE POWER STEERING ECU ASSEMBLY (for 1NZ-FE, 2NZ-FE)
20.REMOVE STEERING COLUMN ASSEMBLY
Disconnect all the connectors and disengage all the wire harness clamps from the steering column assembly.
Do not pull the wire harness.
for 1NR-FE, 2NR-FE:
Disconnect the 2 connectors from the power steering ECU assembly.
Disengage the wire harness clamp to separate the wire harness from the instrument panel reinforcement assembly.
Remove the bolt, 2 nuts and steering column assembly from the instrument panel reinforcement assembly.
45879A
21.REMOVE BREAK AWAY CAPSULE
Remove the 2 break away capsules from the steering column assembly.