Make sure to release the vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.
47201
1.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
44772
2.DISCONNECT CHECK VALVE TO CONNECTOR TUBE HOSE (for Automatic Transaxle and CVT)
Loosen the 2 hose clips and disconnect the 2 check valve to connector tube hoses from the 2 brake vacuum check valve assemblies.
44772
3.DISCONNECT CHECK VALVE TO CONNECTOR TUBE HOSE (for Manual Transaxle)
Loosen the hose clip and disconnect the check valve to connector tube hose from the brake vacuum check valve assembly.
58910C
4.REMOVE REAR CONSOLE BOX ASSEMBLY (for 1NZ-FE, 2NZ-FE)
57533B
5.REMOVE FRONT FLOOR CENTER BRACE (for 1NZ-FE, 2NZ-FE)
57533B
6.REMOVE FRONT FLOOR CENTER BRACE (for 1NR-FE, 2NR-FE)
17410
7.REMOVE FRONT EXHAUST PIPE ASSEMBLY (for 1NZ-FE, 2NZ-FE)
17410
8.REMOVE FRONT EXHAUST PIPE ASSEMBLY (for 1NR-FE, 2NR-FE)
for Sedan:
Click hereEngine / Hybrid System>1NR-FE FUEL>FUEL TANK(for TMT Made)>REMOVAL
for Hatchback:
Click hereEngine / Hybrid System>1NR-FE FUEL>FUEL TANK(for TMT Made)>REMOVAL
51441C
9.REMOVE ENGINE UNDER COVER RH (w/o Metal Type Under Cover)
51451A
10.REMOVE CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)
51405A
11.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)
12305
12.REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH (for 1NZ-FE, 2NZ-FE)
12305
13.REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH (for 1NR-FE, 2NR-FE)
Place a wooden block on a jack underneath the engine assembly.
Remove the 4 bolts, 2 nuts and the engine mounting insulator sub-assembly RH from the timing chain cover assembly and vehicle.
84340
14.REMOVE STOP LIGHT SWITCH ASSEMBLY
15.SEPARATE WIRE HARNESS
47101A
16.REMOVE BRAKE PEDAL RETURN SPRING
47264D
17.REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS
| *1 | Brake Master Cylinder Push Rod Clevis |
| *2 | Clevis Lock Nut |
Loosen the clevis lock nut of the brake master cylinder push rod clevis.
Remove the clip and push rod pin to separate the brake master cylinder push rod clevis from the brake pedal sub-assembly.
Remove the brake master cylinder push rod clevis and the clevis lock nut from the brake booster assembly.
44610
18.REMOVE BRAKE BOOSTER ASSEMBLY
for 1NR-FE, 2NR-FE:
Disconnect the connector.
Disengage the brake tube clamp to separate the brake tubes from the body.
Remove the 4 nuts to separate the brake booster assembly from the body.
Rotate the brake booster assembly as shown in the illustration and remove it.
Do not damage the brake tubes.
Remove the brake booster gasket from the brake booster assembly.