Home › Vehicle Interior › INTERIOR PANELS / TRIM › ROOF HEADLINING(for TMMIN Made Sedan) › 2017.10–2018.01
RM30M0E _58 Vehicle Interior _017120 INTERIOR PANELS / TRIM _0333258 ROOF HEADLINING(for TMMIN Made Sedan) A

INTERIOR PANELS / TRIM  ROOF HEADLINING(for TMMIN Made Sedan)  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY RH

Hide 2.REMOVE REAR SEAT ASSEMBLY (for Fixed Seat Type)

Hide 3.REMOVE REAR SEAT ASSEMBLY (for Separate Seat Type)

Hide 62112 4.REMOVE COWL SIDE TRIM BOARD LH

a.
B346903

Remove the clip.


b.

Disengage the 2 clips and the guide and remove the cowl side trim board LH.


Hide 62111C 5.REMOVE COWL SIDE TRIM BOARD RH

HINT:

Use the same procedure as for the LH side.


Hide 62312B 6.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

a.
B346904

Remove the front door opening trim weatherstrip LH.


Hide 62311B 7.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Use the same procedure as for the LH side.


Hide 62212 8.REMOVE FRONT PILLAR GARNISH LH

a.

except 6 speakers:

i.
B346905

Disengage the 2 clips and the 2 guides and remove the front pillar garnish LH.



b.

for 6 speakers:

i.

Disengage the 2 clips and the 2 guides.


ii.

Disconnect the connector and remove the front pillar garnish LH.



Hide 62211 9.REMOVE FRONT PILLAR GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 62332A 10.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

a.
B346906

Remove the rear door opening trim weatherstrip LH.


Hide 62331A 11.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Use the same procedure as for the LH side.


Hide 73220 12.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH

Hide 73210 13.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 62414A 14.REMOVE CENTER PILLAR LOWER GARNISH LH

a.
B346907

Disengage the 2 claws and the 2 clips and the 2 guides and remove the center pillar lower garnish LH.


Hide 62413A 15.REMOVE CENTER PILLAR LOWER GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 62412B 16.REMOVE CENTER PILLAR UPPER GARNISH LH

a.
B346908

Remove the 2 screws.


b.

Disengage the clip.


c.

Pass the floor anchor of the front seat outer seat belt assembly LH through the center pillar upper garnish LH and remove the center pillar upper garnish LH.


Hide 62411B 17.REMOVE CENTER PILLAR UPPER GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 73370 18.DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH

Hide 73360 19.DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 62552F 20.REMOVE REAR SEAT SIDE GARNISH LH

a.

for Separate Seat Type:

i.
B352909

Remove the clip.


ii.

Disengage the 2 claws and the clip and the 2 guides and remove the rear seat side garnish LH.



b.

for Fixed Seat Type:

i.

Disengage the 2 claws and the clip and the 2 guides and remove the rear seat side garnish LH.



Hide 62551F 21.REMOVE REAR SEAT SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 62472A 22.REMOVE ROOF SIDE INNER GARNISH LH

a.
B346910

Disengage the 4 clips.


b.

Disengage the guide and remove the roof side inner garnish LH.


Hide 62471A 23.REMOVE ROOF SIDE INNER GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 81260A 24.REMOVE MAP LIGHT ASSEMBLY

Hide 74610A 25.REMOVE ASSIST GRIP SUB-ASSEMBLY

HINT:

Use the same procedure to remove all assist grip sub-assemblies.


a.
B342715C01
1.917,1.292 1.625,0.802 true 1.479,0.604 1.792,0.76 0.313,0.156 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the 2 assist grip covers.

NOTICE:

Do not forcibly pry the assist grip covers to prevent them from being deformed.



b.
B342716

Disengage the 2 clips and remove the assist grip.


c.

Remove the 2 clips from the vehicle body.


Hide 63339A 26.REMOVE ROOF HEADLINING SERVICE HOLE COVER (w/ Cover)

HINT:

Use the same procedure to remove all roof headlining service hole covers.


a.
B346911

Using a clip remover, remove the 2 roof headlining service hole covers.


Hide 74320 27.REMOVE VISOR ASSEMBLY LH

a.
B346912

Disengage the guide.


b.

Remove the 2 screws and visor assembly LH.


Hide 74310 28.REMOVE VISOR ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 74348C 29.REMOVE VISOR HOLDER LH

a.
B223017E01
1.115,0.281 1.344,0.438 0.229,0.156 10 false (1) 2.146,1.677 2.375,1.833 0.229,0.156 10 false (2) 1.833,0.406 2.146,0.604 0.313,0.198 10 false 45°

Turn the visor holder LH approximately 45° and pull it out as shown in the illustration.


b.

Disengage the 2 claws and remove the visor holder LH.


Hide 74348B 30.REMOVE VISOR HOLDER RH

HINT:

Use the same procedure as for the LH side.


Hide 31.REMOVE ROOF HEADLINING ASSEMBLY

a.

for front pillar RH side:

i.

Disconnect the connector.


ii.

Remove the bolt.


iii.

Disengage the guide.


iv.

Using a clip remover, remove the 2 clamps.

B342718C02
0.417,4.5 0.542,3.917 false 0.417,4.5 1.031,4.313 false 1.365,0.813 1.479,1.396 1.479,1.396 0.938,1.229 true 0.583,1.333 0.385,1.01 true 5.615,0.792 5.24,0.583 true 0.25,0.844 0.563,1 0.313,0.156 10 false *b 1.5,1.385 1.813,1.542 0.313,0.156 10 false *a 0.271,4.51 0.583,4.667 0.313,0.156 10 false *a 5.052,0.458 5.365,0.615 0.313,0.156 10 false *a
*a Clamp *b Guide




b.

for front pillar LH side:

i.

Disconnect the connector.


ii.

Using a clip remover, remove the 2 clamps.



c.

for rear pillar RH side:

i.

Disconnect the connector.


ii.

Using a clip remover, remove the clamp.



d.

Using a clip remover, remove the 4 clips.


e.
B346913

Remove the roof headlining assembly from the vehicle through the rear passenger side door.

NOTICE:

Do not damage the roof headlining assembly or body interior.