Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
58910C
2.REMOVE REAR CONSOLE BOX ASSEMBLY (for Integrated Type)
58901A
3.REMOVE REAR CONSOLE BOX ASSEMBLY (for Separate Type)
4.LOOSEN PARKING BRAKE CABLE
46430
5.SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY
6.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
42431
7.REMOVE REAR DISC
8.INSPECT REAR AXLE HUB BEARING LOOSENESS
Using a dial indicator, check for looseness near the center of the rear axle hub and bearing assembly.
0.05 mm (0.00197 in.)
Ensure that the dial indicator is set perpendicular to the measurement surface.
Keep the magnet of the dial indicator away from the rear speed sensor.
If the looseness is more than the maximum, replace the rear axle hub and bearing assembly.
9.INSPECT REAR AXLE HUB RUNOUT
Using a dial indicator, check for runout on the surface of the rear axle hub and bearing assembly outside the rear axle hub bolt.
0.07 mm (0.00276 in.)
Ensure that the dial indicator is set perpendicular to the measurement surface.
Make sure to set the tip of the dial indicator towards the outside of the rear axle hub bolts.
Keep the magnet of the dial indicator away from the rear speed sensor.
If the runout is more than the maximum, replace the rear axle hub and bearing assembly.
42431
10.INSTALL REAR DISC
11.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
46430
12.INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
13.INSTALL REAR WHEEL
14.INSPECT AND ADJUST PARKING BRAKE LEVER TRAVEL
58910C
15.INSTALL REAR CONSOLE BOX ASSEMBLY (for Integrated Type)
58901A
16.INSTALL REAR CONSOLE BOX ASSEMBLY (for Separate Type)