Home › Drivetrain › K312 CVT › PARK / NEUTRAL POSITION SWITCH › 2017.10–2018.01
RM30M0E _52 Drivetrain _052969 K312 CVT _0259995 PARK / NEUTRAL POSITION SWITCH A

K312 CVT  PARK / NEUTRAL POSITION SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 17880 3.REMOVE AIR CLEANER HOSE ASSEMBLY

Hide 17801 5.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 17701 6.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 58910C 10.REMOVE REAR CONSOLE BOX ASSEMBLY (for Integrated Type)

Hide 58910C 11.REMOVE REAR CONSOLE BOX ASSEMBLY (for Separate Type)

Hide 58816D 12.REMOVE NO. 1 FRONT CONSOLE BOX INSERT (for TMT Made)

Hide 58817A 13.REMOVE NO. 2 FRONT CONSOLE BOX INSERT (for TMT Made)

Hide 58911A 14.REMOVE NO. 1 SIDE BOX PANEL (for TMT Made)

Hide 58912C 15.REMOVE NO. 2 SIDE BOX PANEL (for TMT Made)

Hide 58916 16.REMOVE BOX BOTTOM MAT (for TMT Made)

Hide 58839A 17.REMOVE CONSOLE BOX HOLE COVER (for TMT Made)

Hide 58810J 18.REMOVE CONSOLE BOX ASSEMBLY (for TMT Made)

Hide 33820B 19.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

NOTICE:

To prevent damage to the transmission control cable assembly and transmission floor shift assembly, disconnect the transmission floor shift assembly side of the transmission control cable assembly before disconnecting the continuously variable transaxle assembly side.


a.

Apply the parking brake and move the shift lever to N.


b.
C381177

Disconnect the end of the transmission control cable assembly from the transmission floor shift assembly.


c.
C261951

Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.


d.

Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.


Hide 84540 20.REMOVE PARK/NEUTRAL POSITION SWITCH

a.
C304843

Disconnect the park/neutral position switch connector.


b.

Remove the nut, washer and control shaft lever from the continuously variable transaxle assembly.


c.
C304845

Using a screwdriver, bend back the tabs of the lock plate.


d.

Remove the lock nut and lock plate from the park/neutral position switch.


e.
C304844

Remove the 2 bolts and park/neutral position switch from the continuously variable transaxle assembly.