Home › Drivetrain › K312 CVT › TRANSMISSION CONTROL CABLE › 2017.10–2018.01
RM30M0E _52 Drivetrain _052969 K312 CVT _0259996 TRANSMISSION CONTROL CABLE A

K312 CVT  TRANSMISSION CONTROL CABLE  REMOVAL  


PROCEDURE

Hide 17880 1.REMOVE AIR CLEANER HOSE ASSEMBLY

Hide 17801 3.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 17701 4.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 58910C 8.REMOVE REAR CONSOLE BOX ASSEMBLY (for Integrated Type)

Hide 58910C 9.REMOVE REAR CONSOLE BOX ASSEMBLY (for Separate Type)

Hide 58816D 10.REMOVE NO. 1 FRONT CONSOLE BOX INSERT (for TMT Made)

Hide 58817A 11.REMOVE NO. 2 FRONT CONSOLE BOX INSERT (for TMT Made)

Hide 58911A 12.REMOVE NO. 1 SIDE BOX PANEL (for TMT Made)

Hide 58912C 13.REMOVE NO. 2 SIDE BOX PANEL (for TMT Made)

Hide 58916 14.REMOVE BOX BOTTOM MAT (for TMT Made)

Hide 58839A 15.REMOVE CONSOLE BOX HOLE COVER (for TMT Made)

Hide 58810J 16.REMOVE CONSOLE BOX ASSEMBLY (for TMT Made)

Hide 57533B 17.REMOVE FRONT FLOOR CENTER BRACE (for TMMIN Made)

Hide 57533B 18.REMOVE FRONT FLOOR CENTER BRACE (for TMT Made)

Hide 17410 19.REMOVE FRONT EXHAUST PIPE ASSEMBLY (for TMMIN Made)

Hide 17410 20.REMOVE FRONT EXHAUST PIPE ASSEMBLY (for TMT Made)

Hide 58151 21.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR

a.
C288562

Remove the 2 bolts, nut and front No. 1 floor heat insulator from the body.


Hide 33820B 22.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

NOTICE:

To prevent damage to the transmission control cable assembly and transmission floor shift assembly, disconnect the transmission floor shift assembly side of the transmission control cable assembly before disconnecting the continuously variable transaxle assembly side.


a.

Apply the parking brake and move the shift lever to N.


b.
C381177

Disconnect the end of the transmission control cable assembly from the transmission floor shift assembly.


c.
C381178C05
0.583,1.406 1.073,0.885 true 0.448,1.427 0.76,1.625 0.313,0.198 10 true *1
*1 Nut
V100135

Rotate approximately 180°
V100136

Pull out


Rotate the nut of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, separate the transmission control cable assembly from the transmission floor shift assembly.

NOTICE:

Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.



d.
C261951

Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.


e.

Remove the clip and separate the transmission control cable assembly from the No. 1 transmission control cable bracket.


f.
C282044

Remove the 3 nuts and transmission control cable assembly from the body.