1. PRECAUTION
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
17880
3.REMOVE AIR CLEANER HOSE ASSEMBLY
4.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
17801
5.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
17701
6.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
28800
7.REMOVE BATTERY
74431
8.REMOVE BATTERY TRAY
74410
9.REMOVE BATTERY CARRIER ASSEMBLY
58910C
10.REMOVE REAR CONSOLE BOX ASSEMBLY (for Integrated Type)
58910C
11.REMOVE REAR CONSOLE BOX ASSEMBLY (for Separate Type)
58816D
12.REMOVE NO. 1 FRONT CONSOLE BOX INSERT (for TMT Made)
for LHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>UPPER INSTRUMENT PANEL>REMOVAL
for RHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>REMOVAL
58817A
13.REMOVE NO. 2 FRONT CONSOLE BOX INSERT (for TMT Made)
58911A
14.REMOVE NO. 1 SIDE BOX PANEL (for TMT Made)
58912C
15.REMOVE NO. 2 SIDE BOX PANEL (for TMT Made)
58916
16.REMOVE BOX BOTTOM MAT (for TMT Made)
58839A
17.REMOVE CONSOLE BOX HOLE COVER (for TMT Made)
58810J
18.REMOVE CONSOLE BOX ASSEMBLY (for TMT Made)
33820B
19.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
To prevent damage to the transmission control cable assembly and transmission floor shift assembly, disconnect the transmission floor shift assembly side of the transmission control cable assembly before disconnecting the continuously variable transaxle assembly side.
Apply the parking brake and move the shift lever to N.
Disconnect the end of the transmission control cable assembly from the transmission floor shift assembly.
Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.
Remove the clip and separate the transmission control cable assembly from the No. 1 transmission control cable bracket.
84540
20.REMOVE PARK/NEUTRAL POSITION SWITCH
Disconnect the park/neutral position switch connector.
Remove the nut, washer and transmission control shaft lever from the continuously variable transaxle assembly.
Using a screwdriver, pry off the tabs of the lock plate.
Remove the lock nut and lock plate from the park/neutral position switch.
Remove the 2 bolts and pull out the park/neutral position switch from the continuously variable transaxle assembly.