55781E
1.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
87810
2.REMOVE INNER REAR VIEW MIRROR ASSEMBLY
62112
3.REMOVE COWL SIDE TRIM BOARD LH
62111C
4.REMOVE COWL SIDE TRIM BOARD RH
Use the same procedure as for the LH side.
62312B
5.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Disconnect the front door opening trim weatherstrip LH to the extent that the front pillar garnish LH can be removed.
62311B
6.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
62212
7.REMOVE FRONT PILLAR GARNISH LH
w/o Curtain Shield Airbag:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Hatchback)>REMOVAL
w/ Curtain Shield Airbag:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Hatchback)>REMOVAL
62211
8.REMOVE FRONT PILLAR GARNISH RH
Use the same procedure as for the LH side.
81260A
9.REMOVE MAP LIGHT ASSEMBLY
74610A
10.REMOVE ASSIST GRIP SUB-ASSEMBLY
11.REMOVE ROOF HEADLINING SERVICE HOLE COVER (w/ Cover)
74320
12.REMOVE VISOR ASSEMBLY LH
74310
13.REMOVE VISOR ASSEMBLY RH
Use the same procedure as for the LH side.
74348C
14.REMOVE VISOR HOLDER LH
74348B
15.REMOVE VISOR HOLDER RH
Use the same procedure as for the LH side.
63310
16.REMOVE ROOF HEADLINING ASSEMBLY
Slightly lower the front section of the roof headlining assembly so that the windshield glass can be removed.
Do not damage the roof headlining assembly or body interior.
It is not necessary to completely remove the roof headlining assembly.
56111
17.REMOVE WINDSHIELD GLASS
|
Protective Tape |
Apply protective tape to the installation area on the windshield glass on the vehicle body.
| *a | Wooden Block |
| *b | Plastic Sheet |
| *c | Piano Wire |
Pass a piano wire between the vehicle body and windshield glass from the interior.
Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
Cut off the adhesive by pulling the piano wire around the windshield glass.
When separating the windshield glass, take care not to damage the paint or interior and exterior ornaments.
To prevent the safety pad from being scratched when removing the windshield glass, place a plastic sheet between the piano wire and safety pad.
| *a | Matchmarks |
Place matchmarks on the windshield glass and vehicle body on the locations indicated in the illustration.
Matchmarks are not necessary if the windshield glass is not going to be reused.
Using suction cups, disengage the windshield glass stopper and remove the windshield glass.
| *A | for 1-piece Type | *B | for 2-piece Type |
| *1 | No. 1 Windshield Glass Stopper | *2 | No. 2 Windshield Glass Stopper |
Be careful not to drop the windshield glass.
Leave as much adhesive on the vehicle body as possible when removing the windshield glass.
To prevent the windshield glass from dropping when performing this operation, be sure to hold the windshield glass using suction cups.
There are No. 2 windshield glass stoppers and No. 1 windshield glass stoppers on the windshield glass. Be careful not to damage the windshield glass when cutting off the adhesive.
Depending on vehicles, 1-piece or 2-piece type stoppers are used.
Using suction cups, remove the windshield glass.
Be careful not to drop the windshield glass.
Leave as much adhesive on the vehicle body as possible when removing the windshield glass.
56117D
18.REMOVE WINDSHIELD GLASS ADHESIVE DAM
| *a | Back Side |
Using a scraper, remove the windshield glass adhesive dam.
Be careful not to damage the windshield glass.
Be sure to replace the windshield glass adhesive dam with a new one.
56115A
19.REMOVE NO. 1 WINDSHIELD GLASS STOPPER (for 1-piece Type)
| *a | Back Side |
Using a scraper, remove the 2 No. 1 windshield glass stoppers.
Be careful not to damage the windshield glass.
Be sure to replace the 1-piece type No. 1 windshield glass stoppers with a new pair of 2-piece type No. 1 and No. 2 windshield glass stoppers.
56116C
20.REMOVE NO. 2 WINDSHIELD GLASS STOPPER (for 2-piece Type)
| *a | Back Side |
Using a scraper, remove the 2 No. 2 windshield glass stoppers.
Be careful not to damage the windshield glass.
Be sure to replace the No. 2 windshield glass stoppers with new ones.
56115A
21.REMOVE NO. 1 WINDSHIELD GLASS STOPPER (for 2-piece Type)
Remove the 2 No. 1 windshield glass stoppers.
Be sure to replace the No. 1 windshield glass stoppers with new ones.