1.INSTALL CLIP
Install a new clip.
64381A
2.INSTALL PACKAGE TRAY TRIM HANGER
Use the same procedure for both sides.
Install the package tray trim hanger.
82185
3.INSTALL NO. 2 BACK DOOR WIRE
Engage the 7 clamps to install the No. 2 back door wire.
Connect the 2 connectors.
81006
4.INSTALL CENTER STOP LIGHT SET
81952D
5.INSTALL REAR LIGHT COVER
81270
6.INSTALL LICENSE PLATE LIGHT ASSEMBLY
84840G
7.INSTALL BACK DOOR OPENER SWITCH ASSEMBLY
76801
8.INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
81590A
9.INSTALL REAR LIGHT ASSEMBLY LH
81580D
10.INSTALL REAR LIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
69350
11.INSTALL BACK DOOR LOCK ASSEMBLY
85143R
12.INSTALL REAR WIPER MOTOR GROMMET
85110R
13.INSTALL REAR WIPER MOTOR ASSEMBLY
74811B
14.INSTALL DOOR PULL HANDLE
Engage the 4 claws to install the door pull handle.
67848
15.INSTALL BACK DOOR SERVICE HOLE COVER LH
Engage the 2 claws and 2 guides to install the back door service hole cover LH.
67847E
16.INSTALL BACK DOOR SERVICE HOLE COVER RH
Use the same procedure as for the LH side.
67751
17.INSTALL BACK DOOR TRIM BOARD
Engage the 11 clips to install the back door trim board.
67005B
18.INSTALL BACK DOOR PANEL CUSHION
Use the same procedure for both sides.
Install the back door panel cushion.
19.INSTALL REAR WIPER ARM AND BLADE ASSEMBLY
85292A
20.INSTALL REAR WIPER ARM HEAD CAP
85345R
21.INSTALL REAR WASHER NOZZLE SUB-ASSEMBLY
85345R
22.INSPECT REAR WASHER NOZZLE SUB-ASSEMBLY
85345R
23.ADJUST REAR WASHER NOZZLE SUB-ASSEMBLY
76889D
24.INSTALL NO. 2 REAR SPOILER CLIP (w/ Rear Spoiler)
Install a new No. 2 rear spoiler clip.
76871
25.INSTALL REAR SPOILER (w/ Rear Spoiler)
76894D
26.INSTALL REAR SPOILER COVER LH (w/ Rear Spoiler)
76893A
27.INSTALL REAR SPOILER COVER RH (w/ Rear Spoiler)
Use the same procedure as for the LH side.
75444
28.INSTALL NO. 4 LUGGAGE COMPARTMENT DOOR PLATE (w/ Grade Mark)
75443
29.INSTALL NO. 3 BACK DOOR NAME PLATE (w/ Engine Displacement Mark)
75442A
30.INSTALL NO. 2 BACK DOOR NAME PLATE
75441E
31.INSTALL NO. 1 BACK DOOR NAME PLATE (w/ Brand Mark)
75129C
32.INSTALL REAR LICENSE PLATE CUSHION
Clean vehicle installation surface.
Remove the release paper from a new rear license plate cushion.
| *a | Mark Position |
Install the rear license plate cushions as shown in the illustration.
Press the 2 rear license plate cushions.