The illuminated entry system controls the engine switch illumination.
Before replacing the certification ECU (smart key ECU assembly), refer to Service Bulletin.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Entry&Start / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Power/Engine SW Light | Engine switch illumination | OFF or ON | w/ Smart Entry and Start System |
| Tester Display |
|---|
| Power/Engine SW Light |
Engine switch illumination comes on.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the engine switch.
for 1NR-FE LHD: Click hereEngine / Hybrid System>1NR-FE STARTING>ENGINE SWITCH(for LHD)>REMOVAL
for 1NR-FE RHD: Click hereEngine / Hybrid System>1NR-FE STARTING>ENGINE SWITCH(for RHD)>REMOVAL
for 2NR-FE LHD: Click hereEngine / Hybrid System>2NR-FE STARTING>ENGINE SWITCH(for LHD)>REMOVAL
for 2NR-FE RHD: Click hereEngine / Hybrid System>2NR-FE STARTING>ENGINE SWITCH(for RHD)>REMOVAL
Inspect the engine switch.
for 1NR-FE LHD: Click hereEngine / Hybrid System>1NR-FE STARTING>ENGINE SWITCH(for LHD)>INSPECTION
for 1NR-FE RHD: Click hereEngine / Hybrid System>1NR-FE STARTING>ENGINE SWITCH(for RHD)>INSPECTION
for 2NR-FE LHD: Click hereEngine / Hybrid System>2NR-FE STARTING>ENGINE SWITCH(for LHD)>INSPECTION
for 2NR-FE RHD: Click hereEngine / Hybrid System>2NR-FE STARTING>ENGINE SWITCH(for RHD)>INSPECTION
Engine switch illumination is normal.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 1NR-FE LHD) | B |
| NG (for 1NR-FE RHD) | C |
| NG (for 2NR-FE LHD) | D |
| NG (for 2NR-FE RHD) | E |
A
B
C
D
E
Disconnect the F43 certification ECU (smart key ECU assembly) connector.
Disconnect the F13 engine switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F13-9 (SWIL) - F43-19 (SWIL) | Always | Below 1 Ω |
| F13-6 (AGND) - F43-24 (AGND) | Always | Below 1 Ω |
| F13-9 (SWIL) or F43-19 (SWIL) - Body ground | Always | 10 kΩ or higher |
| F13-6 (AGND) or F43-24 (AGND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG