Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
1. PRECAUTION
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
55606
3.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for TMMIN Made)
55606
4.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for TMT Made)
55480D
5.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for TMT Made)
55432B
6.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (for TMMIN Made)
55432B
7.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (for TMT Made)
73900
8.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
45287
9.REMOVE LOWER STEERING COLUMN COVER (for TMMIN Made)
45287
10.REMOVE LOWER STEERING COLUMN COVER (for TMT Made)
89611
11.REMOVE ENGINE SWITCH
Disengage the 2 claws to separate the engine switch from the No. 2 lower center instrument panel finish panel.
Disconnect the engine switch connector to remove the engine switch.