Home › Engine / Hybrid System › 2NR-FE STARTING › ENGINE SWITCH(for LHD) › 2017.10–2018.01
RM30M0E _51 Engine / Hybrid System _053950 2NR-FE STARTING _0335433 ENGINE SWITCH(for LHD) A

2NR-FE STARTING  ENGINE SWITCH(for LHD)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55606 3.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for TMMIN Made)

Hide 55606 4.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for TMT Made)

Hide 55480D 5.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for TMT Made)

Hide 55432B 6.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (for TMMIN Made)

Hide 55432B 7.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (for TMT Made)

Hide 73900 8.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

Hide 45287 9.REMOVE LOWER STEERING COLUMN COVER (for TMMIN Made)

Hide 45287 10.REMOVE LOWER STEERING COLUMN COVER (for TMT Made)

Hide 89611 11.REMOVE ENGINE SWITCH

a.
A307903

Disengage the 2 claws to separate the engine switch from the No. 2 lower center instrument panel finish panel.


b.

Disconnect the engine switch connector to remove the engine switch.