11302A
1.INSTALL TIMING CHAIN COVER OIL SEAL
2.INSTALL STUD BOLT
12205B
3.INSTALL VENTILATION CASE SUB-ASSEMBLY
11310
4.INSTALL TIMING CHAIN COVER SUB-ASSEMBLY
Remove any remaining seal packing material.
Clean the contact surfaces of the timing chain cover sub-assembly, cylinder head sub-assembly, cylinder block sub-assembly and confirm that no oil, moisture, or other foreign matter is on the surfaces.
Install a new oil pump gasket to the cylinder block sub-assembly.
Apply seal packing to the timing chain cover sub-assembly as shown in the following illustration.
| *a | Toyota Genuine Seal Packing Black, Three Bond 1207B | *b | Toyota Genuine Seal Packing 1282B, Three Bond 1282B |
| *c | 3.5 to 5.0 mm (0.138 to 0.197 in.) | *d | 3.0 mm (0.118 in.) |
| *e | 10.0 mm (0.394 in.) | *f | 13.6 mm (0.535 in.) |
| *g | 12.0 mm (0.472 in.) | *h | 13.0 to 15.0 mm (0.512 to 0.591 in.) |
| *i | 3.5 to 4.5 mm (0.138 to 0.177 in.) | *j | 7.0 mm (0.276 in.) |
| *k | 3.5 mm (0.138 in.) | *l | 3.0 to 4.0 mm (0.118 to 0.157 in.) |
Engine Water Pump Assembly: Toyota Genuine Seal Packing 1282B, Three Bond 1282B or equivalent
Other: Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent
If there is oil on the contact surfaces, wipe them with an oil-free cloth before applying seal packing.
Install the timing chain cover sub-assembly within 3 minutes and tighten the bolts within 10 minutes of applying seal packing.
After applying seal packing to the timing chain cover sub-assembly, install the oil filter bracket within 10 minutes.
Do not start the engine for at least 2 hours after installation.
Temporarily install the timing chain cover sub-assembly with the 12 bolts.
| Item | Length |
|---|---|
| Bolt (A) | 80 mm (3.150 in.) |
| Bolt (B), (C) | 70 mm (2.756 in.) |
| Bolt (D) | 40 mm (1.575 in.) |
| Bolt (E) | 45 mm (1.772 in.) |
Install a new oil filter bracket gasket to the timing chain cover sub-assembly.
Temporarily install the oil filter bracket with the 3 bolts.
| Item | Length |
|---|---|
| Bolt (A) | 80 mm (3.150 in.) |
| *a | Engine Water Pump Assembly Side |
Install a new water pump gasket to the timing chain cover sub-assembly.
Temporarily install the engine water pump assembly with the 5 bolts.
| Item | Length |
|---|---|
| Bolt (F) | 45 mm (1.772 in.) |
| Bolt (G) | 20 mm (0.787 in.) |
Fully tighten the timing chain cover sub-assembly with the 20 bolts in the order shown in the illustration.
Wipe off any excess seal packing.
16620D
5.INSTALL V-RIBBED BELT TENSIONER ASSEMBLY
6.INSTALL CYLINDER BLOCK DRAIN COCK PLUG
11302R
7.INSTALL TIMING GEAR COVER TIGHT PLUG
13471
8.INSTALL CRANKSHAFT PULLEY
15104
9.INSTALL OIL STRAINER SUB-ASSEMBLY
12101
10.INSTALL OIL PAN SUB-ASSEMBLY