The fuel injector assemblies are installed to the intake manifold, and perform fuel injection in response to signals from the ECM. If there is a malfunction in a fuel injector assembly circuit, a DTC is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | DTC Output from | Priority |
|---|---|---|---|---|---|---|---|
| P020111 | Cylinder 1 Injector "A" Circuit Short to Ground | Short to ground in injector assembly(No. 1 Cylinder - 1) circuit (3 trip detection logic) | ·
Fuel injector assembly ·
Open or short in fuel injector circuit ·
ECM |
Comes on | DTC stored | Engine | A |
| P020112 | Cylinder 1 Injector "A" Circuit Short to Battery | Short to power source circuit in injector assembly(No. 1 Cylinder - 1) (3 trip detection logic) | ·
Fuel injector assembly ·
Open or short in fuel injector circuit ·
ECM |
Comes on | DTC stored | Engine | A |
| P020113 | Cylinder 1 Injector "A" Circuit Open | Open in injector assembly(No. 1 Cylinder - 1) circuit (3 trip detection logic) | ·
Fuel injector assembly ·
Open or short in fuel injector circuit ·
ECM |
Comes on | DTC stored | Engine | A |
| P020211 | Cylinder 2 Injector "A" Circuit Short to Ground | Short to ground in injector assembly(No. 2 Cylinder - 1) circuit (3 trip detection logic) | ·
Fuel injector assembly ·
Open or short in fuel injector circuit ·
ECM |
Comes on | DTC stored | Engine | A |
| P020212 | Cylinder 2 Injector "A" Circuit Short to Battery | Short to power source circuit in injector assembly(No. 2 Cylinder - 1) (3 trip detection logic) | ·
Fuel injector assembly ·
Open or short in fuel injector circuit ·
ECM |
Comes on | DTC stored | Engine | A |
| P020213 | Cylinder 2 Injector "A" Circuit Open | Open in injector assembly(No. 2 Cylinder - 1) circuit (3 trip detection logic) | ·
Fuel injector assembly ·
Open or short in fuel injector circuit ·
ECM |
Comes on | DTC stored | Engine | A |
| P020311 | Cylinder 3 Injector "A" Circuit Short to Ground | Short to ground in injector assembly(No. 3 Cylinder - 1) circuit (3 trip detection logic) | ·
Fuel injector assembly ·
Open or short in fuel injector circuit ·
ECM |
Comes on | DTC stored | Engine | A |
| P020312 | Cylinder 3 Injector "A" Circuit Short to Battery | Short to power source circuit in injector assembly(No. 3 Cylinder - 1) (3 trip detection logic) | ·
Fuel injector assembly ·
Open or short in fuel injector circuit ·
ECM |
Comes on | DTC stored | Engine | A |
| P020313 | Cylinder 3 Injector "A" Circuit Open | Open in injector assembly(No. 3 Cylinder - 1) circuit (3 trip detection logic) | ·
Fuel injector assembly ·
Open or short in fuel injector circuit ·
ECM |
Comes on | DTC stored | Engine | A |
| P21CF11 | Cylinder 1 Injector "B" Circuit Short to Ground | Short to ground in injector assembly(No. 1 Cylinder - 2) circuit (3 trip detection logic) | ·
Fuel injector assembly ·
Open or short in fuel injector circuit ·
ECM |
Comes on | DTC stored | Engine | A |
| P21CF12 | Cylinder 1 Injector "B" Circuit Short to Battery | Short to power source circuit in injector assembly(No. 1 Cylinder - 2) (3 trip detection logic) | ·
Fuel injector assembly ·
Open or short in fuel injector circuit ·
ECM |
Comes on | DTC stored | Engine | A |
| P21CF13 | Cylinder 1 Injector "B" Circuit Open | Open in injector assembly(No. 1 Cylinder - 2) circuit (3 trip detection logic) | ·
Fuel injector assembly ·
Open or short in fuel injector circuit ·
ECM |
Comes on | DTC stored | Engine | A |
| P21D011 | Cylinder 2 Injector "B" Circuit Short to Ground | Short to ground in injector assembly(No. 2 Cylinder - 2) circuit (3 trip detection logic) | ·
Fuel injector assembly ·
Open or short in fuel injector circuit ·
ECM |
Comes on | DTC stored | Engine | A |
| P21D012 | Cylinder 2 Injector "B" Circuit Short to Battery | Short to power source circuit in injector assembly(No. 2 Cylinder - 2) (3 trip detection logic) | ·
Fuel injector assembly ·
Open or short in fuel injector circuit ·
ECM |
Comes on | DTC stored | Engine | A |
| P21D013 | Cylinder 2 Injector "B" Circuit Open | Open in injector assembly(No. 2 Cylinder - 2) circuit (3 trip detection logic) | ·
Fuel injector assembly ·
Open or short in fuel injector circuit ·
ECM |
Comes on | DTC stored | Engine | A |
| P21D111 | Cylinder 3 Injector "B" Circuit Short to Ground | Short to ground in injector assembly(No. 3 Cylinder - 2) circuit (3 trip detection logic) | ·
Fuel injector assembly ·
Open or short in fuel injector circuit ·
ECM |
Comes on | DTC stored | Engine | A |
| P21D112 | Cylinder 3 Injector "B" Circuit Short to Battery | Short to power source circuit in injector assembly(No. 3 Cylinder - 2) (3 trip detection logic) | ·
Fuel injector assembly ·
Open or short in fuel injector circuit ·
ECM |
Comes on | DTC stored | Engine | A |
| P21D113 | Cylinder 3 Injector "B" Circuit Open | Open in injector assembly(No. 3 Cylinder - 2) circuit (3 trip detection logic) | ·
Fuel injector assembly ·
Open or short in fuel injector circuit ·
ECM |
Comes on | DTC stored | Engine | A |
After replacing the ECM, perform idle learning.
Click hereEngine / Hybrid System>1KR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
If P020111, P020112, P020113, P21CF11, P21CF12 or P21CF13 are output, inspect both the fuel injector circuit (No. 1 cylinder - 1) and fuel injector circuit (No. 1 cylinder - 2).
If P020211, P020212, P020213, P21D011, P21D012 or P21D013 are output, inspect both the fuel injector circuit (No. 2 cylinder - 1) and fuel injector circuit (No. 2 cylinder - 2).
If P020311, P020312, P020313, P21D111, P21D112 or P21D113 are output, inspect both the fuel injector circuit (No. 3 cylinder - 1) and fuel injector circuit (No. 3 cylinder - 2).
Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
Pre-procedure1
Disconnect the fuel injector assembly connector.
Turn the ignition switch to ON.
Procedure1
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F4-1 (#10) - Body ground | Ignition switch ON | 11 to 14 V |
| F5-1 (#10) - Body ground | Ignition switch ON | 11 to 14 V |
| F6-1 (#10) - Body ground | Ignition switch ON | 11 to 14 V |
| F7-1 (#10) - Body ground | Ignition switch ON | 11 to 14 V |
| F8-1 (#10) - Body ground | Ignition switch ON | 11 to 14 V |
| F9-1 (#10) - Body ground | Ignition switch ON | 11 to 14 V |
The vehicle wire harness connector that connects to the fuel injector assembly can be connected to either of the 2 fuel injector assemblies of the same cylinder.
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None.
OK
NG
OK
NG
Pre-procedure1
Disconnect the fuel injector assembly connector.
Disconnect the ECM connector.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition | Output DTC |
|---|---|---|---|
| F4-2 (#1) - D50-102 (#1) | Always | Below 1 Ω | P020111,P020112,P020113 |
| F7-2 (#4) - D50-131 (#4) | Always | Below 1 Ω | P21CF11,P21CF12,P21CF13 |
| F5-2 (#2) - D50-133 (#2) | Always | Below 1 Ω | P020211,P020212,P020213 |
| F8-2 (#5) - D50-100 (#5) | Always | Below 1 Ω | P21D011,P21D012,P21D013 |
| F6-2 (#3) - D50-101 (#3) | Always | Below 1 Ω | P020311,P020312,P020313 |
| F9-2 (#6) - D50-132 (#6) | Always | Below 1 Ω | P21D111,P21D112,P21D113 |
| F4-2 (#1) or D50-102 (#1) - Body ground | Always | 10 kΩ or higher | P020111,P020112,P020113 |
| F7-2 (#4) or D50-131 (#4) - Body ground | Always | 10 kΩ or higher | P21CF11,P21CF12,P21CF13 |
| F5-2 (#2) or D50-133 (#2) - Body ground | Always | 10 kΩ or higher | P020211,P020212,P020213 |
| F8-2 (#5) or D50-100 (#5) - Body ground | Always | 10 kΩ or higher | P21D011,P21D012,P21D013 |
| F6-2 (#3) or D50-101 (#3) - Body ground | Always | 10 kΩ or higher | P020311,P020312,P020313 |
| F9-2 (#6) or D50-132 (#6) - Body ground | Always | 10 kΩ or higher | P21D111,P21D112,P21D113 |
According to the connection condition of the vehicle wire harness connector that connects to the fuel injector assembly, check that there is continuity between either of the terminal pairs.
The vehicle wire harness connector that connects to the fuel injector assembly can be connected to either of the 2 fuel injector assemblies of the same cylinder.
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None.
OK
NG
Pre-procedure1
Remove the EFI-MAIN NO. 1 relay from the No. 1 engine room relay block and junction block assembly.
Disconnect the fuel injector assembly connector.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 5 (EFI-MAIN NO. 1 relay) - F4-1 (#10) | Always | Below 1 Ω |
| 5 (EFI-MAIN NO. 1 relay) - F7-1 (#10) | Always | Below 1 Ω |
| 5 (EFI-MAIN NO. 1 relay) - F5-1 (#10) | Always | Below 1 Ω |
| 5 (EFI-MAIN NO. 1 relay) - F8-1 (#10) | Always | Below 1 Ω |
| 5 (EFI-MAIN NO. 1 relay) - F6-1 (#10) | Always | Below 1 Ω |
| 5 (EFI-MAIN NO. 1 relay) - F9-1 (#10) | Always | Below 1 Ω |
| 5 (EFI-MAIN NO. 1 relay) or F4-1 (#10) - Body ground | Always | 10 kΩ or higher |
| 5 (EFI-MAIN NO. 1 relay) or F7-1 (#10) - Body ground | Always | 10 kΩ or higher |
| 5 (EFI-MAIN NO. 1 relay) or F5-1 (#10) - Body ground | Always | 10 kΩ or higher |
| 5 (EFI-MAIN NO. 1 relay) or F8-1 (#10) - Body ground | Always | 10 kΩ or higher |
| 5 (EFI-MAIN NO. 1 relay) or F6-1 (#10) - Body ground | Always | 10 kΩ or higher |
| 5 (EFI-MAIN NO. 1 relay) or F9-1 (#10) - Body ground | Always | 10 kΩ or higher |
The vehicle wire harness connector that connects to the fuel injector assembly can be connected to either of the 2 fuel injector assemblies of the same cylinder.
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None.
OK
NG