12601B
1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
44774
2.DISCONNECT UNION TO CONNECTOR TUBE HOSE
3. OPERATION CHECK
| *a | Vacuum Gauge |
| *b | Plug |
Connect the hose of the vacuum gauge to the vacuum pump assembly.
Start the engine and warm it up for more than 2 minutes.
With the engine idling, check the vacuum of the vacuum pump assembly.
More than 86.7 kPa (650 mmHg, 25.6 in.Hg)
If the pressure is less than the standard, replace the vacuum pump assembly.
Always perform this operation check procedure after replacing the vacuum pump assembly.
Remove the vacuum gauge from the vacuum pump assembly.
44774
4.CONNECT UNION TO CONNECTOR TUBE HOSE
12601B
5.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY