43410
1.REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
43457
2.REMOVE DRIVE SHAFT BEARING BRACKET
36113D
3.REMOVE TRANSFER CASE OIL SEAL RH
| *1 | Transfer Case Oil Seal RH |
Using SST, remove the transfer case oil seal RH from the No. 1 transfer case cover.
Do not scratch the press-fitting surface of the transfer case oil seal RH.
36113D
4.INSTALL TRANSFER CASE OIL SEAL RH
| *1 | Transfer Case Oil Seal RH |
Coat the lip of a new drive shaft oil seal RH with MP grease.
Using SST and a hammer, tap in a new transfer case oil seal RH as shown in the illustration.
7.5 to 8.5 mm (0.296 to 0.334 in.)
Tap the transfer case oil seal RH uniformly so that the transfer case oil seal RH is straight.
Do not tap the transfer case oil seal RH in too far.
43457
5.INSTALL DRIVE SHAFT BEARING BRACKET
43410
6.INSTALL FRONT DRIVE SHAFT ASSEMBLY RH