Home › Drivetrain › CLUTCH › CLUTCH PEDAL SWITCH › from 2020.09
RM36W0E _52 Drivetrain _089426 CLUTCH _0424694 CLUTCH PEDAL SWITCH A

CLUTCH  CLUTCH PEDAL SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the clutch pedal switch removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced (for G16E-GTS and except G16E-GTS, RHD)
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)

CAUTION:
B394719

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


HINT:
for G16E-GTS, except G16E-GTS RHD

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 55606 1.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 84520 2.REMOVE CLUTCH START SWITCH ASSEMBLY

a.
C437884C02
0.083,0.073 0.323,0.313 0.24,0.24 12 true *A 0.052,2.521 0.292,2.76 0.24,0.24 12 true *B
*A for LHD
*B for RHD


Disconnect the clutch start switch assembly connector.


b.

Remove the nut and clutch start switch assembly from the clutch pedal support sub-assembly.

NOTICE:

To prevent damage to the clutch start switch assembly, make sure not to rotate it during removal.



Hide 3.REMOVE STEERING COLUMN ASSEMBLY (except G16E-GTS)

Hide 31453A 4.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN (except G16E-GTS)

Hide 5.REMOVE CLUTCH PEDAL SUPPORT ASSEMBLY (except G16E-GTS)

Hide 88280A 6.REMOVE CLUTCH SWITCH ASSEMBLY (except G16E-GTS)

a.
C446410C01
0.24,2.219 0.615,2.458 0.375,0.24 12 false *B 0.208,0.208 0.583,0.448 0.375,0.24 12 false *A
*A for LHD
*B for RHD


Loosen the nut and remove the clutch switch assembly from the clutch pedal support sub-assembly.