Brake Warning Light Remains ON
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
If any of the following conditions are detected, the BRAKE warning light remains on:- The ECU connectors are disconnected from the skid control ECU.
- The brake fluid level is insufficient.
- The parking brake is applied.
- The EBD is defective.
WIRING DIAGRAM




INSPECTION PROCEDURE
| 1. PREPARE FOR INSPECTION |
Check that both of the following conditions are satisfied.
- The brake fluid level in the brake master cylinder reservoir is correct.
- The parking brake is released.
- HINT:
- When the ABS warning light remains illuminated, repair the malfunctions in the ABS system first.
- The brake fluid level in the brake master cylinder reservoir is correct.
| NEXT | |
| 2. CHECK DTC |
Check if any ABS DTCs are output (Click here).
- Result:
Result
Proceed to
DTC not output
A
DTC output
B
|
|
||||
| A | |
| 3. CHECK CAN COMMUNICATION SYSTEM |
Check if the CAN communication system DTC is output (Click here).
- Result:
Result
Proceed to
DTC not output
A
DTC output
B
|
|
||||
| A | |
| 4. CHECK CONNECTOR CONNECTION CONDITION |
Check if the skid control ECU connector is connected securely.
- OK:
- The connector is connected securely.
|
|
||||
| OK | |
| 5. INSPECT PARKING BRAKE SWITCH ASSEMBLY |
Disconnect the parking brake switch connector.

Measure the resistance.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
D21-1 - Body ground
Parking brake switch ON
(Switch pin released)
Below 1 Ω
D21-1 - Body ground
Parking brake switch OFF
(Switch pin pushed in)
10 kΩ or higher
|
|
||||
| OK | |
| 6. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - PARKING BRAKE SWITCH ASSEMBLY) |
Disconnect connector 4C of the main body ECU (Click here).

Disconnect the parking brake switch connector.
Measure the resistance.
- Standard Resistance:
Tester Connection
Specified Condition
4C-2 (PKB) - D21-1
Below 1 Ω
4C-2 (PKB) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 7. INSPECT BRAKE FLUID LEVEL WARNING SWITCH |
Remove the reservoir tank cap and strainer.

Disconnect the brake fluid level warning switch connector.
Measure the resistance.
- HINT:
- A float is placed inside the reservoir. Its position can be changed by increasing or decreasing the brake fluid level.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
A36-1 - A36-2
Float up (Switch OFF)
10 kΩ or higher
A36-1 - A36-2
Float down (Switch ON)
Below 1 Ω
- HINT:
- If there is no problem after the above check is finished, adjust the brake fluid level to the MAX level.
|
|
||||
| OK | |
| 8. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BRAKE FLUID LEVEL WARNING SWITCH) |
Disconnect the skid control ECU connector.

Disconnect the brake fluid level warning switch connector.
Measure the resistance.
- Standard Resistance:
Tester Connection
Specified Condition
A39-20 (LVL2) - A36-2
Below 1 Ω
A39-20 (LVL2) - Body ground
10 kΩ or higher
A36-1 - Body ground
Below 1 Ω
|
|
||||
| OK | |
| 9. INSPECT COMBINATION METER |
Inspect the combination meter (Click here).
|
|
||||
| OK | ||
| ||
